p3.JPG (77.59 KB, 下載次數: 0)
2007-12-29 12:43 上傳
作者: gibson 時間: 2007-12-29 12:54
I think the inp 12.2v = your power input.
D. peak = delta peak depends on your batteries, if normal or new batteries, I will set it at 3mV. This is to set the cut off peak. If old batteries, I will set it at 4 or 5mV in order to get fully charge.
This is only my own opinions!!
作者: mschumi 時間: 2007-12-29 13:04
原帖由 gibson 於 2007-12-29 12:54 發表
I think the inp 12.2v = your power input.
D. peak = delta peak depends on your batteries, if normal or new batteries, I will set it at 3mV. This is to set the cut off peak. If old batteries, I ...
gib神兄,請問可謂 cut off peak 哩?
作者: gibson 時間: 2007-12-29 13:12
This is the point of your battery if fully charged, it would sudden change, your charger is to catch this change to define your battery is fully charge or not. If you set it too high, it may course over charge, if too low, under charge.
So if your batteries are brand new or in good condition, set it at 3mv, if your battery could fully charged. Keep it at 3mv.. This is my concept or the terms that I used may not be correct, but the principle is the same...
作者: mschumi 時間: 2007-12-29 13:17
Thanks!
gip神兄
作者: gibson 時間: 2007-12-29 13:29
I am gibson, not yet to become gib神!!
作者: mschumi 時間: 2007-12-29 13:34
yes sir
| 歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://jk.rc-evo.com/xbbs/) | Powered by Discuz! X3.2 |