標題: TLP X15 Problem [打印本頁] 作者: kennethwsl 時間: 2008-2-1 09:14 標題: TLP X15 Problem 想問下用僅X15的brother，我arm arm 買左部.. 第一晚用okay.. 但第2晚開始.. 間唔中佢會有'dak dak dak dak ' 的聲.. 然後會出'Invalid Input Voltage' 的error message.. 有時一插電就會有lee 個error..
舊接收電係新的...
arm arm 個次. 我set 3 cycle.. 佢cycle 1 2 都無時... cycle 3 mo la la 自己'dak dak dak dak ' -> 'Invalid Input Voltage'..
Mm.. 煩..
有無人有類似experience?作者: Brushless 時間: 2008-2-1 10:28
why you have to cycle the 接收電?!!! you want more punch from it?!!!作者: kennethwsl 時間: 2008-2-1 10:54
Mm hi Brother,,
no I just want to test the charger.. and I only have the receiver battery at that moment..
and b4 this X15, I only use those cheap cheap no display charger.. so not very familar with the operation ..
I wonder if I did anything wrong and if I should bring it back to the shop for enquiry..作者: Brushless 時間: 2008-2-1 11:24
Usually reciever battery is relatively low end product, I'm afraid that the 3 cycles (especially if the current is set too high) may damge the battery and causing apparently charger failure,
Of course, it still could be the charger problem, since the QC of certain mainland made elctronic device may not be that good.作者: kennethwsl 時間: 2008-2-1 11:43
icic.. Thanks v. much brother!! I just use 0.5 a to charge.. hope it's fine la...
anyway. I tried another battery this morning.. also have the same error message as 'Invalid input vol' ..
better get back to the shop to check I guess.
.. 