RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: 请教齿比!!! [打印本頁]

作者: airqiu 時間: 2008-5-4 19:46
標題: 请教齿比!!!
想请问下各位高手````小弟购买了一个无刷6.5T的电机````
正想安装在TA03上`````TAMIYA建议齿比是9.16:1````
那么````我该用什么多少T的马达齿轮呢`?

作者: michael.chum 時間: 2008-5-4 20:04
which track are you running? we need to know?

or you can do this. after run check the motor, does it really hot! if its really hot try try any other one

作者: airqiu 時間: 2008-5-4 21:58
唔系挂````要甘麻烦噶`?有无玩TA03既高手教下我啊`!!??

作者: 老人家 時間: 2008-5-4 23:55
which track are you running? we need to know?

or you can do this. after run check the motor, does it really hot! if its really hot try try any other one

作者: jacobchu2007 時間: 2008-5-5 09:17

原帖由 airqiu 於 2008-5-4 19:46 發表

 登錄/註冊後可看大圖

想请问下各位高手````小弟购买了一个无刷6.5T的电机````
正想安装在TA03上`````TAMIYA建议齿比是9.16:1````
那么````我该用什么多少T的&#3953 ...

I think you cannot use 6.5T on TA03. The gear ratio of the chassis itself is 2.XX. The spur gear is 80 and you should use motor gear less than 18 to fit the requirement. If not, your motor will become very hot. Also, the design of TA03 is not good for low T motor, the motor is covered by plastic and not easy to radiate heat. I think TA03 should not use too low T motor.

This is the general rule for using motor gear. For racing or running on track as other Chings had pointed out that it also depends on the traction of the track, the size of the track etc.

作者: airqiu 時間: 2008-5-7 13:12
哇````我学到好多野啊``多谢晒各位先！！！！其实我系用黎玩drift的
`````我应该用几多T既motor先岩呢`？马达齿应该要选择多少T呢`？
麻烦高手指点！！！！谢谢！！

歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://jk.rc-evo.com/xbbs/)