原帖由 stanley_wwy 於 2008-5-21 11:48 發表
follow the standard setting from the manual....it's already quite good for most conditions.
it runs okay with the standard setting in ACO and PYC.
but for sure you need to make minor adjustments ...
原帖由 stanley_wwy 於 2008-5-21 11:48 發表
follow the standard setting from the manual....it's already quite good for most conditions.
it runs okay with the standard setting in ACO and PYC.
but for sure you need to make minor adjustments ...
原帖由 Fluke 於 2008-5-21 13:46 發表
"you may decrease the rear toe-in to like 1-1.5 degree to reduce the oversteer"
The situation should be at the opposite side,decrease rear toe-in , more chance to increase oversteer.
原帖由 valklai 於 2008-5-21 12:15 發表
Brother,
In fact, i can't find out which page is show those setting.
Can u tell me which pages is indicate that standard set-up??
原帖由 stanley_wwy 於 2008-5-21 16:25 發表
oh...yea....thanks for pointing out...
I intented to mean decrease understeer.....coz RRR standard setting uses same hardness for front tires and rear tires (37/37), not like other cars using u ...
歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://jk.rc-evo.com/xbbs/) | Powered by Discuz! X3.2 |