RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: 買控問題 [打印本頁]

作者: raybee1211    時間: 2008-6-11 05:05
標題: 買控問題
請問如果我係買 am mj  2pl   3pm  三隻,除左 多左channak外  三隻既反應時間係咪一樣架?我而家用緊mj  反應好慢 ,弓大`又唔想換 2.4g
如果1000內 買邊隻係最好?  要有兩隻接收  ,請大家比d意見  thx
作者: jacobchu2007    時間: 2008-6-11 08:47
3pm is FM, not AM.
Sure 3pm is the best of the three. Response time is faster and the signal is stronger.
3pm one set (one transmitter + 1 receiver+ 1 pair of crystals+ 2 3003 servos) ~ $8xx
          extra one receiver ~$3XX + extra 1 pair of c rystals ~12X
2pl  FM one set (one transmitter + 1 receiver+ 1 pair of crystals+ 2 3003 servos) ~ $5xx
         extra one receiver ~$3XX + extra 1 pair of c rystals ~12X
2pl  AM one set (one transmitter + 1 receiver+ 1 pair of crystals+ 2 3003 servos) ~ $4xx
         extra one receiver ~$18X + extra 1 pair of c rystals ~5X

2pl has better response than MJ

[ 本帖最後由 jacobchu2007 於 2008-6-11 12:07 編輯 ]
作者: 倫ae86    時間: 2008-6-11 10:37
師兄咩叫多左channal??
係唔係可以玩兩個servo嫁??
作者: jacobchu2007    時間: 2008-6-11 12:11
原帖由 倫ae86 於 2008-6-11 10:37 發表
師兄咩叫多左channal??
係唔係可以玩兩個servo嫁??


Channels = The number of ways that the transmitter can be set to control.

Receiver usually has 2 channels, 3 channels, 4 channels, 6 chanels, 8 channels, 9 channels or even more....

Usually 2 to 4 channels are for cars.

For normal car, 2 channels receiver, channel 1 is for controlling the wheel direction
                                     channel 2 is for controlling the speed of the motor
  channel 3 for channging gear sets in oil car
  
For aeroplane or helicopter, they will usually use 4 to 9 channels, depends on different requirements, each channel can be set to control.
作者: raybee1211    時間: 2008-6-11 20:13
唔該晒 jacobchu2007   thx
作者: prodanny    時間: 2008-6-11 22:42
我有2PL同3PM, 3PM多d野可以設定, 想詳細比較可以下載到Futaba下載說明書.   




歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://jk.rc-evo.com/xbbs/) Powered by Discuz! X3.2