標題: First LunchBox - Assembly [打印本頁] 作者: swswsw 時間: 2008-8-1 10:48 標題: First LunchBox - Assembly Just bought a new LunchBox for casual RC fun.
[attach]180797[/attach]
Nice Packing in a Box.
[attach]180798[/attach]
Bulb Set
[attach]180799[/attach]
Ball Bearing
[attach]180800[/attach]
Break-in Motor
[attach]180801[/attach]
Painting
[attach]180802[/attach]
Assembly
[attach]180803[/attach]
Charging NiMH 4600mah
[attach]180804[/attach]
Chasis Completed
[attach]180805[/attach]
Painting
[attach]180806[/attach]
Nearly Completed!!
[attach]180807[/attach]
BIG Wheel!!
[attach]180808[/attach]
Slip Shot....
[ 本帖最後由 swswsw 於 2008-8-1 10:58 編輯 ]作者: swswsw 時間: 2008-8-1 11:38 Overall Comment:
Nice RC Car from TAMIYA...
Easy Assembly within 3hours... Good fitting for all parts.
Special Note:
1. Front suspensions bottom joints not to be lock-tight as the angle of free motion is not enough. Once strong impact to the front wheel, the bottom nut will break!!
[attach]180816[/attach]
2. Four Screws in the Battery Cabin need to be covered, or will scretch the battery.
[attach]180813[/attach]
Future Modification:
1. Lower Front Suspensions by 10-15mm.
2. Change the existing 540 to Brushless Motor
[attach]180814[/attach]
[ 本帖最後由 swswsw 於 2008-8-1 11:43 編輯 ]作者: mikewu 時間: 2008-8-1 11:43
You guys are NUTS! Brushless on Lunchboxes now!?? 作者: swswsw 時間: 2008-8-1 11:55
Will Low it down at the Lowest possible.
Should be OK with Brushless Motor in getting a reasonible control after some modications
