標題: ex-10慢爬4ws問題~ [打印本頁] 作者: 飛飛 時間: 2008-8-6 14:58 標題: ex-10慢爬4ws問題~ 請問十仔點先可以前後反方向?用y插只可同方向.......有無師兄教路作者: 馬田 時間: 2008-8-6 15:07
後面隻servo有無位反轉裝?作者: 飛飛 時間: 2008-8-6 23:26
點樣反轉裝? 作者: 飛飛 時間: 2008-8-7 03:37
有無師兄可以教下我......而家架野好似鬼咁打斜行支控又無鬼用無得set........作者: 飛飛 時間: 2008-8-7 03:56
係咪即係尾個servo黑線插白線,白線插黑線咁?作者: jacobchu2007 時間: 2008-8-7 10:50
You can try to use two servos from differental manufactureer. I had tried before in my TLT-1. I use MG995 at front and Sanwa(?) 577 at the rear side. Front and rear side turn at different direction. If you use the servos from the same make, it certainly will turn at same direction.
There are other methods from other C hing, some of them use the third channel to control. But it is not good, I think.作者: lowtech 時間: 2008-8-7 13:44 標題: 回復 6# 的帖子 Sure not!White wire is data,red wire is +ve and black wire is -ve.
The servo have built in IC,Wrongly connect +ve and -ve will burn the servo!
You can try to instore the plastic servo arm up-side-down then the turning direction will reverse.
Hope this help.作者: 飛飛 時間: 2008-8-7 18:35 標題: 回復 7# 的帖子 但係我巳經有兩個servo係手~作者: 飛飛 時間: 2008-8-7 18:40
明白喇.....即係只係將正負極掉轉就ok~
但係我又有野想問......就係點樣唔整爛個插頭而可以兩條線掉轉?
唔該哂各位~作者: 馬田 時間: 2008-8-7 22:56 http://www.gpdealera.com/cgi-bin/wgainf100p.pgm?I=FUTM4150
