RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: MG 995 一問 [打印本頁]

作者: zachary 時間: 2008-10-4 00:43
標題: MG 995 一問
用MG 995 係咪用埋BEC 會好D 丫 ??
thx

作者: kaho0338 時間: 2008-10-4 00:55
depends which esc u use ..

作者: edison 時間: 2008-10-4 00:56
Depend on what ESC.
If some ESC BEC output is only have 5V/1A, add BEC is must!!

作者: zachary 時間: 2008-10-4 00:59
我用緊雙星原裝esc 呀
因為我驚燒receiver
幫我睇睇丫, 係咪咁樣駁丫??
thx

[ 本帖最後由 zachary 於 2008-10-4 01:09 編輯 ]

作者: edison 時間: 2008-10-4 11:17
I cannot give any comment depend of your photo.
But some suggest I can give you!
Just remove the red color cable from ESC servo 3P cable is ok!

作者: zachary 時間: 2008-10-4 11:49

原帖由 edison 於 2008-10-4 11:17 發表

 登錄/註冊後可看大圖

I cannot give any comment depend of your photo.
But some suggest I can give you!
Just remove the red color cable from ESC servo 3P cable is ok!

唔明, 即係我而家咁樣駁錯左??

歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://jk.rc-evo.com/xbbs/)