RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: Novak HV maxx setting 問題 [打印本頁]

作者: tatame 時間: 2008-10-10 16:52
標題: Novak HV maxx setting 問題
買左隻novak HV maxx 返黎, 佢有好多項setting, 但有d功能唔多明想請教大家, 仲有裝散熱風扇係d 風吹住heatsink 定從heatsink 抽風走?
同埋built in 得3個profile ~ 點解佢話有profile 4同5 ?

1. MINIMUM BRAKE SETTINGS (10) BLUE LED << 呢個應該係最小break 既力度
Amount of braking applied with first pulse of transmitter throttle information.
--Raising this setting starts the braking at a stronger/higher level.

2. DRAG BRAKE SETTINGS (10) BLUE & AMBER LEDs<< 呢個係咪拖長break 既行程?
Amount of braking applied while transmitter is at neutral. AKA ‘coast’ brakes.
--Raising this setting makes the motor slow down more, without
pushing the transmitter’s trigger into the brake/reverse direction.

3. DEAD BAND SETTINGS (5) BLUE & GREEN LEDs << 呢個真係唔明係乜

Space between Minimum Brake & Minimum Drive, with neutral in middle.
--Raising this setting will increase the ‘free play’, or distance your
trigger must move before forward drive or braking will begin.

4. MINIMUM DRIVE SETTINGS (5) AMBER LED << 呢個係咪第一下油門力度大小??
Amount of forward drive applied with first pulse of transmitter information.
--Raising this setting makes the motor start at a stronger/higher
level so it takes off more aggressively from neutral.

5. THROTTLE CURVE SELECTION (3) GREEN LED << 呢個應該係架車起步爆炸力或柔和起步
Response curve of drive power applied to motor for a given trigger position.
--Changing this setting changes the throttle response of the motor
and ease of low end drivability--Expo has smoother bottom end.

6. BRAKE FREQUENCY (7) RED LED
Frequency at which duty cycle information for braking is sent to the motor.
--Raising this setting makes the brake response smoother and
less aggressive.

7. BRAKES (2) RED, GREEN, & AMBER LEDs 有break 同無break !
--Changing this setting activates/deactivates the ESC’s braking.

8. MOTOR ROTATION (2) 較左係咪前後對調?
--Changing this setting enables/disables Auto-Detect LiPo Cut-Off.

[ 本帖最後由 tatame 於 2008-10-10 16:58 編輯 ]

作者: swswsw 時間: 2008-10-10 23:45
C Hing, just want to ask... which shop is it available?
as I found few shops...
Thks..

作者: tatame 時間: 2008-10-11 23:24

原帖由 swswsw 於 2008-10-10 23:45 發表

 登錄/註冊後可看大圖

C Hing, just want to ask... which shop is it available?
as I found few shops...
Thks..

香港唔洗諗la 全城無貨~有貨o個兩間都係舊既writeoff model~ 我o係外國訂返黎

新版包裝, 有內置lipo cut off 同5mm shaft

作者: 泉 時間: 2008-10-11 23:42
2.模擬有擦摩打靜止時的阻力, 可教強弱
3.中位無反應的位置, 減少摩打因"前"與"靜止"之間的損耗

[ 本帖最後由泉於 2008-10-12 00:58 編輯 ]

作者: swswsw 時間: 2008-10-12 00:47

原帖由 tatame 於 2008-10-11 23:24 發表

 登錄/註冊後可看大圖

香港唔洗諗la 全城無貨~有貨o個兩間都係舊既writeoff model~ 我o係外國訂返黎

新版包裝, 有內置lipo cut off 同5mm shaft

oh... i see.. could you kindly advise which overseas web-site for ordering and how much?
Thks...

作者: tatame 時間: 2008-10-13 14:33

原帖由 swswsw 於 2008-10-12 00:47 發表

 登錄/註冊後可看大圖

oh... i see.. could you kindly advise which overseas web-site for ordering and how much?
Thks...

check PM thanks

作者: tatame 時間: 2008-10-13 14:36

原帖由泉於 2008-10-11 23:42 發表

 登錄/註冊後可看大圖

2.模擬有擦摩打靜止時的阻力, 可教強弱
3.中位無反應的位置, 減少摩打因"前"與"靜止"之間的損耗

多謝指教, 咁MINIMUM DRIVE SETTINGS 係咪即係好似搖控o個個油門setting 咁?? 較1% 以上會架車自己行?? thanks

作者: 泉 時間: 2008-10-14 22:54
MINIMUM DRIVE SETTINGS 即是設定電變靜止起動時輸出, 如果電變教30%, 遙控油門前一度, 電變就會由30%開始起動, 省略了1%至29%的速度, 有一按即彈出的動力, 當起動後會回復正常, 與遙控的punch功能一樣,

但你說 "遙控較1% 以上會架車自己行", 這只是中位移前, 電變只知道油門移前, 所以架車自己行向前

作者: tatame 時間: 2008-10-15 15:18

原帖由泉於 2008-10-14 22:54 發表

 登錄/註冊後可看大圖

MINIMUM DRIVE SETTINGS 即是設定電變靜止起動時輸出, 如果電變教30%, 遙控油門前一度, 電變就會由30%開始起動, 省略了1%至29%的速度, 有一按即彈出的動力, 當起動後會回復正常, 與遙控的punch功能一樣,

但你說 " ...

明白~ 唔該晒師兄~

歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://jk.rc-evo.com/xbbs/)