P1050835a.jpg (92.13 KB, 下載次數: 0)
2008-10-15 20:48 上傳
[ 本帖最後由 gtimax 於 2008-10-15 20:48 編輯 ]
作者: zoozoo 時間: 2008-10-16 08:06
插入去D线可以短D轻D，睇上去整齐D
焊多几次就熟手，唔会好麻烦
作者: AMAT 時間: 2008-10-16 12:31
原帖由 gtimax 於 2008-10-15 20:28 發表
插入個孔完全是多餘的事........浪費時間，直接悍落去就得
，
幾時一齊玩車呀？快車／super stock 都可以！
197380
我唔覺得插落個窿呢個焊法係浪費時間........
我擒晚先焊完,兩秒一個,有幾耐?
一溶,一推,咁就搞掂,我唔知幾難同耐囉.....
作者: AMAT 時間: 2008-10-16 12:43
唔駛焊多幾次......
個原理好簡單......
你電線錫都唔駛上........
你係果個窿到落多O的錫,之後放支電線係果個窿位準備,你支辣雞一辣落去後面O的錫,一溶,一推,搞掂,仲一定實添.
你話就咁辣上去,線又要上錫,果個位又要上錫,又要按住電線辣落去,又驚焊假錫.......同你就咁辣摩打一樣......
我唔覺得會好過辣落個窿到囉.......
作者: gtimax 時間: 2008-10-17 00:09
if you had a lrp tc spec , you will find the wire is too big for the hole. it is the difficulty come from, the method above is not working for that case.
作者: AMAT 時間: 2008-10-17 00:13
原帖由 gtimax 於 2008-10-17 00:09 發表
if you had a lrp tc spec , you will find the wire is too big for the hole. it is the difficulty come from, the method above is not working for that case.
我有TC SPEC的
都係唔太麻煩唧,咪上O的錫落O的線到,再剪多少少.....一樣咁做....
不過,你要堅持你O既方法焊.....我都唔會反對你......
| 歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://jk.rc-evo.com/xbbs/) | Powered by Discuz! X3.2 |