Sxx v2 玩完好熱

都幾熱 wor. 用什麼魔打?

回復 1# billlkyy

齒比都ok, 減少D Boost, 再試試 la.
motor 幾多度?

motor just around 50c
billlkyy 發表於 2010-10-13 00:22

                               
登錄/註冊後可看大圖

減少D ESC's Boost, 再試試.
想快D, 用大小小齒比 la 因為 motor 溫度唔太熱.

you will need to reduce your esc's temp first. the best is to turn off boost. hope the temp is around 60-70C.  (because 85C is very high)
for reference: my friends SXXv2 + 4.5R is only around 60C after 10mins.

when your esc has lower temp, then you can re-gear.

回復 17# evojacky

因為4.0T 的power 大 5.5T 好多,所以電變會熱好多.

5.5 vs 4.0, 速度一定有分別 la

回復 21# billlkyy

Around 60C 好好多 la!
建議先試用大小小齒比，若唔夠快最後先用 boost.

回復 23# billlkyy

You play at JV? (佐敦谷)

Me and several friends are going to JV this coming sat morning.  Come join us if you have time.

回復 27# billlkyy

I will be there on Sat morning as well.  I play a red/white 1/12.  Maybe I will see you then and 吹水 la.

回復 31# evojacky

what esc are you using?  you can add some timing is esc support.

HW1S 有無 boost / turbo?
(ie setting #12,13,14,15)

有 boost, 又有 turbo.
#9 = boost = 進角
#12 = turbo
#13 = boost rpm 起點
#14 = turbo 'full雞' 延期
#15 = boost 速度

試試以下setting:
#9=6/7
#12=7/8
#13=3/4
#14=3
#15=5/6

最好玩4-5圈,check check溫度. 如果太高,必須轉settings.

回復  hardmankam

hobbywing 120a 1S  + Speed passion 5.5R lo ...進角 22.5度.....
evojacky 發表於 2010-10-15 08:54

                               
登錄/註冊後可看大圖

其實用進角=22.5,已經set到好大。所以要快d, 可能要換 4.5r/ 4.0r la.

叫我師夫? 當然 no la! 只是大家分享. 多d人玩,開心好多!

#13 = boost rpm 起點 =  esc 在 xxxx rpm後先加電子進角 (#9)
eg: #13=4  (=7500rpm), esc 在魔打轉到 7500rpm 先會加 boost.

多數 1s+12仔 #13 setting 不要太高 (3k to 7.5k都ok) !

Lipo full within 1 to 2 weeks is ok.
For longer than 1 - 2 weeks, better discharge it until 3.9volts / cell