Very creative to put the ESC at the rear of the motor!
hk_sdu 發表於 2011-3-16 02:22
Thx C-Hing,
To share, this is a trial for three reasons:-
a - reduce of the weight L/R imbalance of the original F104 layout, therefore reduce need of using lead weights
b - increase weight distribution to the rear
c - reduce interference/imbalance of thick wires (3 brushless, 1 sensor wires) to the rear suspension setup (T-bar, spring/damper), and make the drive dynamics/feeling more predictable/consistent.
Downside of course is the exposed rear-end, so needed to put a big rear bumper to protect the setup.
So far the car runs fine at JV. I am using 17.5, thou not quick but seems more stable to drive. |