"BATT. V TOO HIGH" =Error=

Got this message on my CDC Ver 6.0/B charger -- "BATT. V TOO HIGH" =Error=
Does it mean my battery is dead???

may be u have set "1s" to charge "2s" battery la.....
                        set "2s" to charge "3s" also make problems like U
                        set 3.7v to charge 7.4v
                        set 7.4v to charge 11.1v

may be u have set "1s" to charge "2s" battery la.....
                        set "2s" to charge "3s" also make problems like U
                        set 3.7v to charge 7.4v
                      ...
koji1230 發表於 2009-10-30 01:02

                               
登錄/註冊後可看大圖

Thank you thank you.

I am charging NIMH batteries, noted the input voltage surged up to 12V for a few seconds and this error message occured in one pack of Sanyo 3000mah battery. Other packs are fine.

Your battery may be dead

Your battery may be dead
tamiyafan 發表於 2009-10-30 23:09

                               
登錄/註冊後可看大圖

可以拆散舊電 look look 邊舊仲未死??