推介平靚正 engine 比 savaGE 用

原裝個k4.6 開始打柴
又上唔到去2波
解決左好耐都唔得
各位c兄有冇咩
推介平靚正  engine 比 savaGE 用

我個K4.6個單各都係打左柴,都係正唔番,係紅星見到一個EM30 好似880,

Axial 32, STS D30M

SH 28 $9xx

原裝個k4.6 開始打柴
又上唔到去2波
解決左好耐都唔得
各位c兄有冇咩
推介平靚正  engine 比 savaGE 用
lion 發表於 2009-11-25 23:52

                               
登錄/註冊後可看大圖

我推介STS30 engine,coz.零件易買....
but don't buy STS28, coz. the cylinder too thin and very hard to remove from the case.
但上唔到二波未必關副偈事woo,你check清楚你個波箱有冇問題,

sts30而家平左, 當時買要$12xx, 放落沙豬可以狂劈, 扭力大, run左十缸油就來料, 我記得roto-start個尾蓋易打柴, run好行左三兩缸........掃左

整體我自己覺得OK, 另外選30VG

my old engine, they all gone

I bought a .28 engine called EN from "紅星" about a month ago just to replace my original Savage 4.6 engine, its outlook looks like the Axial one (perhaps both are made by the same factory!) and so far it runs ok since, just a bit hard to start when it was new. I think it has .32 too but I did not get that one though as I felt .28 is good enough for me anyway but one of my friends did get the .32 for his truck after he saw mine was running and it seems not bad too, but I think the engine is made in Taiwan, may be you can try it as well.