Intellect 電問題

請問有冇師兄知道Intellect 5000mah電的自放電率?

我在鴨記買左幾粒電自焊黎用, 返屋企度全部0V,
可以充5600mah 1.5V, 好夠爆, 但充滿唔用放係到唔夠兩日跌返去0V,
咁樣是否正常?

好唔正常!!!!兩日都放唔到

如果放2日跌番去0V, 絕對係好唔正常

死電~~ ?????????????

好有問題，冒牌貨都唔出奇？仲要系劣質果種，唔好貪平，去模型店買好d

我排Intellect 4600mah只充30%電後儲存，擺左半年仲有6.8volt

I have similar situiation, buy Intellect 5000mah battery in SSP, very good performance only 2-3 cycles, then can only recharge to 20% and stop. I just wonder those SSP shop are selling 劣質冒牌貨 !!

ps, buying battery in SSP is not 貪平, but KWS salesman attitude is so bad that I don't want to spend money there !!!

我排Intellect 4600mah只充30%電後儲存，擺左半年仲有6.8volt
michaelxl2000 發表於 2010-5-10 23:55

                               
登錄/註冊後可看大圖

    ME TOO AR

請問有冇師兄知道Intellect 5000mah電的自放電率?

我在鴨記買左幾粒電自焊黎用, 返屋企度全部0V,
可以 ...
tscc 發表於 2010-5-10 22:56

                               
登錄/註冊後可看大圖

已壊..............

I bought 3 x intellect 4600mAH from KWS last year, already soldered packs from one of the popular shops.  They have the same problem.  I asked them, and they just said need to store with partial charge, and not full charge.  But the problem still exists.  

No more intellect for me.

回復 13# dennis_wong


    咁...車仔賣5000電咩價位?

請問有冇師兄知道Intellect 5000mah電的自放電率?

我在鴨記買左幾粒電自焊黎用, 返屋企度全部0V,
可以 ...
tscc 發表於 2010-5-10 22:56

                               
登錄/註冊後可看大圖

可能他們新電放得大久沒出售才會這樣，模型店未出售的電有時也會自放電至零V ，但他們的店員有時會自己去再充回電才賣。如果還能充回電而又有力，多數用大電流充放多次後便會回復一定狀態。

Below 0.7v/cell & storage, it will damage/ loss most capacity and non-recoverable by cycling even Ni-CD batteries.

So, Dead-short discharge and following charge method is got most punching but the batteries are also easlier dead.

我在網上查到, 原來ni-mh電drop到0V時陽極內部會氧化而且不能逆轉, 陽極會氧化會加速漏電, 到了0V又會更加氧化, 是惡性循環..........冇得救

我在網上查到, 原來ni-mh電drop到0V時陽極內部會氧化而且不能逆轉, 陽極會氧化會加速漏電, 到了0V又會更加氧 ...
tscc 發表於 2010-5-12 11:35

                               
登錄/註冊後可看大圖

This is good knowledge learning from your bad self experience! sad.....