question on TA05 VDF ?!?

does any body know what is the part number of the aluminum bumper that was on the show room for the TA05 VDF picture link

                               
登錄/註冊後可看大圖

also i miss bb10 too... alot people does? please help...

Many ching have the BB10 problem, it is instruction manual fault AND mis-packing part in the bag. Even many ching rasie the point, however WG, as the agent, took no action to solve the problem for it's customer.
So my only way is to DIY, very simple, just go to buy 4mm plastic ring.
If you have a BB10 in bag D, you need 2 pcs plastic ring
If you do not have BB10 in bag D, then you need 3 pcs.
The BB10 is 4 x 1mm, so even you have this ring, it cannot fill the 3mm gap,
This is my method, not sure if it fit ching's car or not....

登錄/註冊後可看大圖

Should be bag B, not D....

回復 3# gimsink


    ching... i use... alot leftover shims from my trf501x... so now it fits... but WG no good.... we paid... full price.. and i think alot people didn't get bb10... i got 4bb11 no bb10.sighh

Ihave QUESTION.. the steering linkage hit the chassis... so i cut it all off ... now the ball connector not fully cover.. have a whole... u see on the red... but is that normal?

登錄/註冊後可看大圖

我又POST我架VDF...

你地講既問題(無BB10) 我都一樣, 但呢個只係說明書出錯, 盒車內另有一粒藍件先至真, 我玩左兩個星期, 一D問題都無,
反而見到呢度有人講過FULL雞會甩皮帶, 我試過裝 SP2.1 開TURBO都冇事, 有野砌錯定係星星QC問題, 前者可能性應該大D.....

                               
登錄/註冊後可看大圖

                               
登錄/註冊後可看大圖

另外, 頭碼頂推桿我都一樣, 應該話係岩岩好"HI"到, 右邊多虛位少少就岩岩"HI"唔到, 我既解決方法係用cutter cut左一小邊joint位咁就OK, 換左鋁碼可能會好D掛, 未買到1A/1XA...

                               
登錄/註冊後可看大圖

但真正難題係擰到盡會頂碼, 想玩CS又想加大轉向時又要諗下點改... (雖然而家已經好大轉向, 不過多多益善...)

                               
登錄/註冊後可看大圖

原裝VDF 最大轉向 (換左OP 轉向可能會大D掛, 等白老鼠...)

                               
登錄/註冊後可看大圖

FULL雞 NOT 甩皮帶, just the belt easy to fell off the bearing.
I am lucky, no problem on the steering, both side 頭碼推桿岩岩"HI"唔到, very smooth.

Any ching had tested the VDF and can share the setup sheet for our reference ??