鋰電何謂:過放?過滿?

請問
平時要保持住幾多V ?
充到幾多好收手 ?
用到得翻幾 V 唔好再玩落去?

小弟新手求助,謝謝

我平時玩到3.7-8收手

回復 2# bowielum

咁 充到幾多好收手 ?

我4200電，用4A充，部义機會自己收手，一般係4.19-20V

小弟用鋰電差機, 充滿會自動停, 充滿時通常是 8.4v (2s)

如果唔玩一段時間, 咪充一半左右 (有些差機有 Storage Mode), 但我好少擺埋唔玩

玩車時, 多數人會將電變 set 3.2v cut, 即 cut 電時是 6.4v, 但我好少理佢幾多 volt, 感覺腳軟就番埋黎

我就set 3.5v cut

小弟用鋰電差機, 充滿會自動停, 充滿時通常是 8.4v (2s)

如果唔玩一段時間, 咪充一半左右 (有些差機有  ...
IBM 發表於 2010-10-29 17:50

                               
登錄/註冊後可看大圖

    Agree  Ching ! U can feel it la ~~ Sudden Slow !!! PLS Come Back !!! Haha~~

once you feel the car slows suddenly, pls stop it in a safe place and go to pick the car. It is better than drive the car back to the stage

回復 1# fung2010


鋰電何謂:過放?過滿?      ====>  鋰電百科全書

平時要保持住幾多V ? Storage
Most manufacturers recommend discharging the battery to 40% of full charge. In addition, other sources recommend refrigerating (but not freezing) the cell.

充到幾多好收手 ? Most manufacturers claim a maximum and minimum voltage of 4.23  and 3.0 volts per cell. Taking any cell outside these limits can reduce the cell's capacity and ability to deliver full rated current.

用到得翻幾 V 唔好再玩落去? Most manufacturers claim a maximum and minimum voltage of 4.23 and 3.0 volts per cell. Taking any cell outside these limits can reduce the cell's capacity and ability to deliver full rated current.

鋰聚電池的標示電壓是3.7V（伏特），充電截止最高電壓為4.23V，最低放電截止電壓極限是2.8V，充電時超過4.23V或者放電低於3V，都可能造成鋰聚電池嚴重的損壞，甚至燃燒等嚴重損壞。

長時間存放電池3.8v   差電3.8v+0.4v=4.2v     放電3.8v-0.4=3.4v  
如果高出或低過此電壓電池就會慢慢帳起  或會有危險

充到幾多為之滿?

總知部叉機識得自己CUT電..
叉到咁上下佢叉電個A數慢慢會低..
一般叉滿排電係8.4V..
每一CELL大約4.11至4.22
叉好佢會咇咇叫..我指部叉機