環球1/10油房公開賽暨2012世界盃選拔賽資料

環球1/10油房公開賽暨2012世界盃選拔賽

ACO:12 June , 9 October ,

TRC 7 August, 4 December,


賽例及其他資料

Race Format

Rules:

--Will apply the IFMAR Rules with some modifications to the schedule of events.

--3 results out of 4 in the world model 1/10 the 200mm Touring car Race (Open) will be reckoned in to  the qualification of 2012 World Championship Trial

Lap Counting:
AMBrc lap counting system will be used
AMBrc Direct Powered transponder must be used

Numbers of drivers are limited to:
1:10 class: 60 drivers
1:8 class: 30 drivers

Qualify:
10 minutes qualify for each heat in each class
3 rounds of Qualifying Heats. Using best result of each driver to place their seat in main final.   

Main Final:
15 minutes for C, D  ,E & F Main Final
25 minutes for B Main Final
30 minutes for A Main Final

Body

1/8 & 1/10

All drivers must use IFMAR registered Body shell

Foam tires only

1/10 200mm:

All drivers must use 200mm body shell

Only the following holes and sizes are permitted in the body shells:

One 15mm maximum diameter hole in the roof for glow plug access

One 60mm maximum diameter hole in the roof for fuel refill

Both front side windows and the rear window can be removed for ventilation, except for the side rear windows, which must remain intact

One small hole with maximum 10mm diameter can be made for the transponder

One small hole with maximum 10mm diameter can be made for the radio antenna

One small hole with maximum 20mm diameter can be made for the exhaust pipe

No other holes are permitted

Tire

1/8th and 1/10th: Foam tires only

Fuel:

must use (25%)Fuel for the Race.

Checking

Racing cars will be check for analysis and any competitor found to be offending the rules will be disqualified and any race result obtained will be null and void

Car Specification

1/10th Technical Specifications:

The official measurements in these Technical Specifications are the metric measurements.

1)      200 mm Nitro Touring Car which will be 4WD

2)      The engine may have a total capacity of not more than 2.11cc only. The engines may have a maximum of four (4) ports in the liner, including the exhaust port

3)      Maximum 2-speed gearbox allowed

4)      The Fuel tank capacity to be 75 cc including all fuel tubings, filters, etc.

5)      The mufflers and INS boxes have to bear their homologation numbers during the entire competition. The mufflers’ and INS boxes’ measurements (both internally and externally) have to conform with those on the homologation sheet issued by IFMAR.

6)      Front Tyres maximum width:       26 mm

7)      Front Tyres maximum width:       30 mm

8)      Only bodies that are recognized and approved by IFMAR will be allowed.

9)      Overall dimensions:

Maximum width            205mm (with body)

Maximum height           175mm (with wing, body and Gurney strip with 10mm spacer block)

Maximum weight           1725 grams (with empty fuel tank and with timing transponder installed.)

1/8th Technical Specifications:

The official measurements in these Technical Specifications are the metric measurements.

1)      X-ray RX8 which will be 4WD

2)      The engine may have a total capacity of not more than 3.5 cc. No tolerance allowed.

3)      Maximum 2-speed gearbox allowed

4)      The Fuel tank capacity to be 125 cc including all fuel tubings, filters, etc.

5)      The mufflers and INS boxes have to bear their homologation numbers during the entire competition. The mufflers’ and INS boxes’ measurements (both internally and externally) have to conform with those on the homologation sheet issued by IFMAR.

6)      Front Tyres maximum width:       37 mm

7)      Rear Tyres Maximum width:        64 mm

8)      Only bodies that are recognized and approved by IFMAR will be allowed.

9)      Overall dimensions:

Maximum width                    277mm (with body)

Maximum height                    180 mm (with wing, body and Gurney strip with 10mm spacer block)

Maximum weight                   2525grams (with empty fuel tank and timing transponder installed.)



All wheels must not lean out of the body shell
如想報名的賽員請盡快！


或可到這環球網站:http://www.world-model.com/wmcup/rules.asp

隔離台收到以下消息：


請見FEMCA的回覆如下：

We are many moｎths away from knowing how many allocations FEMCA or HK will get

Until we get the unused allocations from the other blocs we have absolutely no idea, and that will not be until 3 months prior to the event.

Each Bloc starts with 32, we can only guarantee 2 per country until such time as we get those allocations from IFMAR.

This is basically the same for every IFMAR event and has never altered over the years


Regards Trevor

咁呀，em.......,我參加TRC場1／8

beebone 發表於 2011-6-15 10:19

                               
登錄/註冊後可看大圖

咁呀，em.......,我參加TRC場1／8

玩埋1/10，可能鬥2場都出到線！

chungtsai 發表於 2011-6-16 10:07

                               
登錄/註冊後可看大圖

玩埋1/10，可能鬥2場都出到線！

可能鬥都唔洗, 得一架RX8

你有多一架我陪你玩

Beebone hing   好多fans,  嗰嗰都想陪佢玩