鑼絲問題

請問有冇師兄知道美制鑼絲點睇 ? 例如 4-40 x 1/2 的話, 要用 3/32 六角批去收, 4-40 代表乜 ?另外公制及美制綜絲牙係唔係一樣 ? 我想幫架 RC10T4 換不銹钢鑼絲, 不過唔知道點買相对的美制鑼絲.....

4-40 x 1/2 -> '4' is the screw size, '40' is the thread count per inch, 1/2 is the length in inches.

http://www.engineersedge.com/screw_threads_chart.htm

tips: go to 新填地街, there are a few screw special shops there.  just give them the size and they know what to give you.  Its better to bring your T4 manual along.

前幾日去大照買不銹鋼鑼絲, 一大包3mm 杯頭波頭乜頭物頭買左2百蚊, 可切兩三架車有排用. 可惜冇2.5mm 六角頭鑼絲, 得十字頭. 有冇師兄知道邊间有2.5mm六角頭 ? 另外順便買美制六角鑼絲比T4用, 大照老細問番我轉頭點解今個星期咁多人揾美制六角 ? 話十年冇發市要訂貨等幾日先有, 嘿嘿....另外老細超好人我同佢吹左陣水佢打左個九折比我, 仲有呀四眼師傅幫我汁料, 對完又對怕弄錯, 直得敬佩 ? KWS D 所謂老細真係要誠心誠意學吓咩係待客之道, 否則真係自食其果 !!

師兄.. 大照在那裡..我都想買螺絲 ...

廣東道九百七十幾號！

gimsink 發表於 2011-8-14 22:51

                               
登錄/註冊後可看大圖

前幾日去大照買不銹鋼鑼絲, 一大包3mm 杯頭波頭乜頭物頭買左2百蚊, 可切兩三架車有排用. 可惜冇2.5mm 六角頭 ...

梗好招乎啦,一粒賺你半元,2百蚊賺你1百蚊去边都好招乎啦..........

This is small money, I don't care how much the other peoples earn, as long as I can huy stuffs in a price that acceptable to me that's fine. Many chings said how cheap they can buy stuffs elasewhere but this is no meaning to me, cus I cannot get the so called "cheap price" even I go to the same place.     

Is a good shop, I also by screw there

I also have a T4. If you can buy, please share with me. Thanks.

gimsink 發表於 2011-8-16 09:06

                               
登錄/註冊後可看大圖

This is small money, I don't care how much the other peoples earn, as long as I can huy stuffs in a  ...

同意，自己俾錢俾得開心，價錢自己又覺得ok就得
如果俾錢都要受氣，咁差嗰一百幾十，唔係話大口氣，但我寧願豪俾佢