RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

 找回密碼
 新玩家註冊
搜索
查看: 1853|回復: 9
打印 上一主題 下一主題
收起左側

點解裝完個Stablizer架車冇咗回彈力???

[複製鏈接]
跳轉到指定樓層
1#
bigben 發表於 2007-9-7 10:51:15 | 只看該作者 回帖獎勵 |倒序瀏覽 |閱讀模式

遊客登錄

您需要 登錄 才可以下載或查看,沒有帳號?新玩家註冊

x
未裝之前架車壓低咗 (用手"禁"低佢) 都有回彈力(用硬彈弓).....

但點解裝完後架車回彈力弱咗好多???

(借圖一用)

[ 本帖最後由 bigben 於 2007-9-7 10:53 編輯 ]
2#
raymen 發表於 2007-9-7 11:43:22 | 只看該作者
Buggy no need that one la.....


*** for 1/10 Touring is ok.

[ 本帖最後由 raymen 於 2007-9-7 12:07 編輯 ]
3#
 樓主| bigben 發表於 2007-9-7 11:56:39 | 只看該作者
i know....
but someone say that it is better for steering and more stable....if the car body is set to be high.....
4#
師傅東 發表於 2007-9-7 12:03:05 | 只看該作者
你架係乜車嚟先?
5#
i-Drift 發表於 2007-9-7 12:31:29 | 只看該作者
Have you tightened the hex screws for holding the bar in place?
6#
 樓主| bigben 發表於 2007-9-7 13:02:59 | 只看該作者
你架係乜車嚟先? ------- Kyosho GP buggy

Have you tightened the hex screws for holding the bar in place? ------ Yes
7#
i-Drift 發表於 2007-9-7 13:05:55 | 只看該作者
It could be the angle or the bar is too stiff. So the car cannot bounce back.
8#
i-Drift 發表於 2007-9-7 13:08:29 | 只看該作者
After you pushed the car down, the car stuck at that position and won't bounce back.

But if you use a finger to slightly push the car upward, at certain point, the car will bounce suddenly. Then the Bar is not set properly.

Try adjusting the 2 bar holders (at the end of the bar) slightly and try again.
9#
 樓主| bigben 發表於 2007-9-7 13:17:39 | 只看該作者
原帖由 i-Drift 於 2007-9-7 13:08 發表
After you pushed the car down, the car stuck at that position and won't bounce back.

But if you use a finger to slightly push the car upward, at certain point, the car will bounce suddenly. T ...


how to adjust..... ??

actually, I tighted the hex screws when the four wheels are off the ground..... is it correct?
10#
vigor 發表於 2007-9-7 22:00:54 | 只看該作者
原帖由 bigben 於 2007-9-7 13:17 發表


how to adjust..... ??

actually, I tighted the hex screws when the four wheels are off the ground..... is it correct?


The mount that holds the anti roll bar should be adjusted so that the whole suspension falls freely without the shocks installed.  Remove the shocks from the lower suspension arms, and adjust the set screws that hold the anti roll bar.
您需要登錄後才可以回帖 登錄 | 新玩家註冊

本版積分規則

手機版|小黑屋|RC EVOLUTION - 遙控工房

GMT+8, 2024-11-15 01:12 , Processed in 0.032135 second(s), 18 queries , Gzip On.

Powered by Discuz! X3.2

© 2001-2013 Comsenz Inc.

快速回復 返回頂部 返回列表