有冇刨殼技術分享?

有冇刨殼技術分享?
要薄又唔穿.please.

haha老師, 你都要做幾多準備wor

我的經驗就是一邊刨一邊睇清楚....一有過龍就補返d筆地再刨 (個人經驗分享,不一定最好)

講到到樣野，一定係搵Henry啦！

羅記~~~~~~~~~~~~~~~~~~~~~~~~~~

羅到唔想羅喇, 好辛苦
羅得快又穿, 羅得慢又累
隻手痺哂嫁

講吓用咩工具呀?

鴨記$25蚊一個既羅頭(鑽石波羅頭)個表面有好多刀片仔咁既
有好多款, 買隻蛋形, 個頭有少少平既就會好刨d, 就手d

乜野叫' 刨殼' ??

原帖由 800mah 於 2007-11-16 01:56 發表

                               
登錄/註冊後可看大圖

乜野叫' 刨殼' ??

rub off the extra plastic from the body to make it lighter than b4, the CG lower than b4 ,
improve acceleration and the reaction in the corner

i see, then maybe the next thing kyosho should do is to produce some 'light weight' mini-z bodies just like what tamiya does with polycarbonates.

原帖由 800mah 於 2007-11-17 19:53 發表

                               
登錄/註冊後可看大圖

i see, then maybe the next thing kyosho should do is to produce some 'light weight' mini-z bodies just like what tamiya does with polycarbonates.

I don't think the Japanese will understand our demand.
Also, producing lighter body shell by making the plastics thinner is a lot more expensive. It is not the same case as using polycarbonates.

原帖由 800mah 於 2007-11-17 19:53 發表

                               
登錄/註冊後可看大圖

i see, then maybe the next thing kyosho should do is to produce some 'light weight' mini-z bodies just like what tamiya does with polycarbonates.

好似我地咁玩係kyosho既客路屬小部份
4wd主打drift, 只係我地玩到佢咁盡
睇番人地外國玩車仔, 主要都係玩下樣, 有基本性能, 絕少DIY創作