AD band on AWD left right how to set?

When I turn it on it fully turn left or right when I turn on the EX 10......

Even I turn left or right on remote or set ST trim also no effect.....

How to reset it or some thing wrong on the pcb?

Please help any high hand....I am only newbie on AD car

首先,就check下粒band有無插好
如果都係唔得,就set支ex10既Adjust VR,去make sure支控既中位係o岩既
都唔得既,就睇黎係粒VR收左工

reset VR not working .....

the forward and backward is ok ga..... so sad.... just install ok can't play...

What is the VR...is that a circle with 3 pin that connect to the servo gear?

or some ic like on pcb?

原帖由 lolman 於 2006-4-3 20:29 發表
reset VR not working .....

the forward and backward is ok ga..... so sad.... just install ok can't play...

What is the VR...is that a circle with 3 pin that connect to the servo gear?

or s ...

無錯
果粒就係VR

BTW I install the MR-02 AD pcb on the AWD.... is that the VR left and right need to relocate??? I mean the line

原帖由 lolman 於 2006-4-3 20:46 發表
BTW I install the MR-02 AD pcb on the AWD.... is that the VR left and right need to relocate??? I mean the line

ha~
上車場問下先得bo

原帖由 lolman 於 2006-4-3 20:46 發表
BTW I install the MR-02 AD pcb on the AWD.... is that the VR left and right need to relocate??? I mean the line

要 REVERSE servo 摩打線,
紅黑對掉

Thx the car run smooth now.... u are so good!