Atomic Motor 一問

想請問大家 ..........本人車子底板 MR-02 chassis is enhanced with the RA-4B FET motor control amp........可否用Atomic 出品既STOCK R Evolution Motor ??因為見到話[...Basic Requirement: MOSFET 3010 x 2 / (1 layer)...].....咁可唔可以用呢 ?? 唔該幫幫忙

你呢塊板剛剛符合最低要求, 不過呢隻摩打都幾貴wor, 有無需要呢?

i think can't use , need modif  fet
STOCK la, safe cheap fast ha ha

嘩，你去咗火星呀 ？今晚唔見你出現就燒咗你個locker!

Okay ga wor.   Mine is also 3010 one layer & using Stock R.  RA-4B FET should be same as AD or 2.4GHz 3010 FETs.

thx.......each brother.......

原帖由 GTRTam 於 2008-5-20 13:06 發表

                               
登錄/註冊後可看大圖

Okay ga wor.   Mine is also 3010 one layer & using Stock R.  RA-4B FET should be same as AD or 2.4GHz 3010 FETs.

2.4Gs have two layrs of 3010 FETs, they have FETs on both sides of the board ga

Yes so how about  RA-4B PCB ? Only have 2 X 3010 ?

RA-4B PCB.......is already Only have 2 X 3010

原帖由 kaka820 於 2008-5-21 09:36 發表

                               
登錄/註冊後可看大圖

RA-4B PCB.......is already Only have 2 X 3010

2 x 3010 = one layer
4 x 3010 = two layers

2.4Gs have two layrs of 3010 FETs, they have FETs on both sides of the board

Ah, already stacked FETS 2x.  Very good.

原帖由 icky 於 2008-5-20 02:17 發表

                               
登錄/註冊後可看大圖

i think can't use , need modif  fet
STOCK la, safe cheap fast ha ha

how much the stock motor???

原帖由 rcplayer 於 2008-5-28 22:14 發表

                               
登錄/註冊後可看大圖

how much the stock motor???

ATOMIC BALL BEARING STOCK 130咁上下啦