CR01 option center drive shaft

Any brother know which option of CR01 drive shaft is the best one? 3-racing? Topcad or Hot Racing?

Hot-racing:

                               
登錄/註冊後可看大圖

3-racing:

                               
登錄/註冊後可看大圖

Topcad:

                               
登錄/註冊後可看大圖

3 racing 同 topcad 糙D

i vote for hot racing and 3 racing......

i have topcad one.....not so good

原帖由 kaho0338 於 2008-9-7 17:38 發表

                               
登錄/註冊後可看大圖

i vote for hot racing and 3 racing......

i have topcad one.....not so good

Thank you for your recommendation!

3 racing is good..
but the pins are loose and u need to tweak a little

原帖由 sunfffd 於 2008-9-7 21:47 發表

                               
登錄/註冊後可看大圖

3 racing is good..
but the pins are loose and u need to tweak a little

really? 3 racing is good?  
You mean need to use some glue to stick the small pins?

yes
i just use glass tape to wrap around the yoke
and it works fine
just field tested today

原帖由 sunfffd 於 2008-9-7 21:58 發表

                               
登錄/註冊後可看大圖

yes
i just use glass tape to wrap around the yoke
and it works fine
just field tested today

Thanks for your quick reply!
Today's i just tested my "fast run" CR01 and finally lost the near shaft...haha.
You can watch my video from:
http://bbs.rc-evo.com/viewthread.php?tid=93796&extra=page%3D1

KWS 邊間有得賣丫??大約幾錢到丫??雙星有冇出過PARTS 丫??
THX

THX!!!

I think Hot Racing is the best one... I try Topcad, not very good...