想買09 問有什麼要改GAR ???

TKS

原庄已經好夠玩，壞了才改啦！

原庄好好玩

but probably after a few runs,
you will want:
Chamber
High Speed Gear
Pipe
Light Shaft
Carbon Fiber upper deck(plastic is really too soft)
then of course carbon fiber lower plate (for good look)
metal bulk head front and rear
engine mod
brake
high travel rear hub
the list can go on and on...


the mod will probably costs twice as much as the car

咁又要支幾嘢啦.......

Spada 09 = 18xx
2 servos = 1000 (about)

assume you already have remotes, receiver, and tools
you can run the car for about 3k and be quite happy

but then you want to be even happier, the happier formula is:
(most Prices are not sure)
Chamber = 2xx?
High Speed Gear = 1xx?
wheel shaft (not dog bone) = 18x
Pipe = 5xx?
Light Shaft = 1xx
Carbon Fiber upper deck = 3xx
then of course carbon fiber lower plate = 3xx
metal bulk head front mid rear = 6xx
metal turning hub = 25x
engine mod = depends, but can cost over 500
brake = 2xx?
high travel rear hub = 1xx?
metal carrying cage = about 100
long throttle arm = 4x

so the little extra happiness costs about 4k, about 150% of the car costs...

I think can classified like this

Level 1 (most needed and cost efficient)
- high speed gear
-1 degree chamber
- light weight center shaft

Level 2 (very useful but cost some money)
- Pipe

Level 3 (still very useful but cost quite a lot)
- Full Carbon Fiber
- Engine Mod

Level 4 (useful, but not very cost efficient)
- Full Metal
- High Travel Hubs

Level 5 (almost useless)
- metal carrying bar
- light weight brake
etc...

WA....要好好考慮
TKS