ko 2.4 g急問

請問ko 2.4g對應怎樣做,(無左說明書)
THX

The binding procedures should as,

1. Hold the button on the back of the module and turn on the Tx.
2. Continue to hold the button until the LED on the module goes out and release the button. The LED will come back on but will be dimmed.
3. Hold the button on the rx and turn on the power to the rx.
4. Once the LED comes on, you can release the button. The LED will go dim and come back on very quickly.
5. Turn the rx and then the Tx off and then turn both back on again.

Hope this can help..

thx

Almost forgot,.. you also can set the fail safe for throttle once complete binding,  -  When the tx and rx are on, hold the trigger at the fail safe position and press the rx button for 3 sec. and release. (when the LED light goes out). You can verify once the tx turned off.