RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

 找回密碼
 新玩家註冊
搜索
查看: 1493|回復: 9
打印 上一主題 下一主題
收起左側

用媽星壳+LED 燈比 Protofom, Parma 壳跑差幾遠

[複製鏈接]
跳轉到指定樓層
1#
joanne 發表於 2009-1-23 13:48:53 | 只看該作者 回帖獎勵 |倒序瀏覽 |閱讀模式

遊客登錄

您需要 登錄 才可以下載或查看,沒有帳號?新玩家註冊

x
各位師兄, 請問如 Tamyia TRF-416 用媽星壳 + LED 燈跑同落跑場用的 Protoform, Parma 等, 會差幾遠 ? Setting 是否亦要因應去調校 ?
2#
 樓主| joanne 發表於 2009-2-4 19:18:51 | 只看該作者
有無邊位師兄幫到忙 ?
3#
chacha 發表於 2009-2-4 20:41:49 | 只看該作者
每個車殼Setting 都有分別,
4#
 樓主| joanne 發表於 2009-2-4 23:59:03 | 只看該作者
5#
chacha 發表於 2009-2-5 08:09:47 | 只看該作者
呢樣野好難講喎,有部份殼可能會偏推,有 D 又偏向彎好,但係跑直路有冇咁定,呢 D 係要憑經驗同自己渣法0黎調整
6#
binary 發表於 2009-2-5 09:13:03 | 只看該作者

回復 1# 的帖子

I had some experience to share when I did a comparison in the past.

Situation:
Same track - Old TRC track
Same chassis and electronics - XRay T2'008 + 10.5R brushless motor
Same tyre - Sorex
Basically everything was the same, just the shell was different.

Shells:
- Tamiya BMW 320i WTCC
- Protoform Speed 6

By using Tamiya BMW shell, I can only consider my car was totally undriveable when comparing with Speed 6, at some corners, I can flat out when using Speed 6 shell, but with the Tamiya BMW shell, the car has to be slowed down quite a lot when going into the same corner.  Overall, the lap time was at least 1 second slower when using that BMW shell..... I remember that the lap time should be around 13s per lap, so now having 1s difference, the margin is quite a lot indeed.

Can't share settings for those 2 shells with you because I had no interest on setting up my car for the BMW shell, I just had one run and then going back to the Protoform shell immediately.  

[ 本帖最後由 binary 於 2009-2-5 09:15 編輯 ]
7#
 樓主| joanne 發表於 2009-2-5 16:59:59 | 只看該作者
原帖由 binary 於 2009-2-5 09:13 發表
I had some experience to share when I did a comparison in the past.

Situation:
Same track - Old TRC track
Same chassis and electronics - XRay T2'008 + 10.5R brushless motor
Same tyre - Sorex
Ba ...

是売的重量分別或是風速影響 ?
8#
AMAT 發表於 2009-2-5 17:15:16 | 只看該作者
原帖由 joanne 於 2009-2-5 16:59 發表

是売的重量分別或是風速影響 ?


車殼會影響O架車O既風壓,從而影響抓地力.

田宮好多車殼都好靚,但係風壓都好差........變成O架車轉灣時下壓,令架車同車呔唔夠抓地力

風壓唔單止車尾有關,車頭亦都有關.
車尾風壓不足,車行直線唔夠直,會撩撩下.
車頭風壓不足,車轉灣時就好推.......

較為好走O既田宮有燈車殼,真係好少........
冇燈殼O既,就NSX,SC430,F430,我來也,SGT GTR R35都OK好走,但全部都好似冇燈杯......
9#
binary 發表於 2009-2-5 17:15:46 | 只看該作者

回復 7# 的帖子

It's all because of downforce and aerodynamic efficiency.
10#
 樓主| joanne 發表於 2009-2-5 17:57:21 | 只看該作者
原帖由 AMAT 於 2009-2-5 17:15 發表


車殼會影響O架車O既風壓,從而影響抓地力.

田宮好多車殼都好靚,但係風壓都好差........變成O架車轉灣時下壓,令架車同車呔唔夠抓地力

風壓唔單止車尾有關,車頭亦都有關.
車尾風壓不足,車行直線唔夠直,會撩撩 ...

咁室內場會比室外好好多 ? 改用大尾翼有無幫助呢 ?
您需要登錄後才可以回帖 登錄 | 新玩家註冊

本版積分規則

手機版|小黑屋|RC EVOLUTION - 遙控工房

GMT+8, 2024-11-17 01:41 , Processed in 0.040737 second(s), 16 queries , Gzip On.

Powered by Discuz! X3.2

© 2001-2013 Comsenz Inc.

快速回復 返回頂部 返回列表