新手砌TT01E有D小問題

呢粒螺絲真係用盡9牛2虎之力都扭唔入,正常唔係應該D冇螺絲牙既位入哂條呔尺個洞到咩

                               
登錄/註冊後可看大圖

另外呢粒杯唔小心整唔見左1粒,有冇得配返粒BEARING

                               
登錄/註冊後可看大圖

THX

HN577 發表於 2011-12-20 21:30

                               
登錄/註冊後可看大圖

呢粒螺絲真係用盡9牛2虎之力都扭唔入,正常唔係應該D冇螺絲牙既位入哂條呔尺個洞到咩

另外呢粒杯唔小心整 ...

果粒bearing有得配,10蚊,期中一間都有

第一幅圖建議換波頭+推桿
用反原裝的話佢會卡住 影響頭避震

第二幅可以配反,打開說明書抄低個大小(**x**x**mm)
kws各模型店幫到你
十元八塊可以解決

THX CHING們迅速的解答
咁我買左SET波頭既話,圖2條呔尺係咪唔洗用返,即係我唔洗哂錢配粒BEARING

第一幅相睇黎，好似入得唔好斜左，應該唔駛好大力就可以入晒
啤鈴放心係可以配到的

HI CHING, ARE YOU SURE THIS IS THE CORRECT SCREW? THE COLOR OF THAT SCREW IS DARK METAL INSTEAD OF SILVER ON MY TT-01E. PLS CHECK THE INSTRUCTION BOOKLET AGAIN.  I AM HIGHLY RECOMMEND YOU TO BUY METAL BEARING, IT REALY HELP TURN .

回復 konglo 的帖子

it is actually a black screw but it appears sliver under camera flashlight.thx for ur commend and i'll go kws to buy the 波頭SET and bearings tmr