有關用Tekin RX8嘅要求？

我諗住甪Tekin RX8 Gen2，係咪要高C數嘅鋰電先Support到隻ESC? 我依家用緊全部都係30C

同埋用RX8需要係電變Set Current Limiter嗎? 如要，set幾多?

有冇用緊RX8電變嘅師兄可以教下小弟?

c hing 剩係知你用rx8叫人如何答你

ed1213 發表於 2014-5-30 11:10
c hing 剩係知你用rx8叫人如何答你

師兄，請問仲有乜嘢要知？

8仔用行1900-2200kV 4S

我見過c hing 1900kv 用25c冇問題(前題d電要正常)
Current limit 可以又低set上去

通常由乜數值開始set？一路加要注意D乜？唔該晒師兄！

ESC are not that related to 'c' gei.... But motor, 1900kv, say for a 1/8 buggy with 4S, 25c / 4000 mah and up should be ok.... 1/8 doesn't draw much amp as SCT or some 1/10 ....  So if you hv some 30c (say 5000mah whatever)

Again, high 'C' won't hurt, keep the car with better punch for longer time, and depends how new and performance of your battery la.... I hv some 45c battery, performe not as good as some 20c after a while...


Bit on general, for 1/8 buggy, under 2000kv motor, 100a (25c  x 4000 mah) would be ok.

Unless you push to 2650kv, and running big heavy monster truck...  Check temperature law...
Set current limited is ok, say 120a, but not a must....  You hv Hotwire already?