焊接問題~電線鬚

唔知點解d鍚同d鬚溶合唔到~~點解呢?????

your surface is to dirty or some oxide . so you must cleaningthe surface to solder area

有冇落埋松香膏呀？

冇丫~落左會易溶合??落係d電線到定係d鍚到呢????????

你支野幾w............

原帖由 阿門 於 2007-11-21 16:53 發表

                               
登錄/註冊後可看大圖

你支野幾w............

80WWWWWWWW

原帖由 chacha 於 2007-11-21 16:00 發表

                               
登錄/註冊後可看大圖

有冇落埋松香膏呀？

琴日我問過4間五金鋪都冇話冇賣呢d野?????咁係邊到買到架?????thx

原帖由 faibs1 於 2007-11-22 08:15 發表

                               
登錄/註冊後可看大圖

琴日我問過4間五金鋪都冇話冇賣呢d野?????咁係邊到買到架?????thx

出去鴨記打個轉 實有

I have never used 松香膏.

just like chopsticks said, keep 你支野 surface clean, apply some 鍚 to both surfaces, then solder them together.

if 你支野 surface is dirty, the heat can't be conducted efficently, it is no longer a 80w  野.

to keep it clean, you can scratch 支野 (when it is hot) on water soaked sponge.

原帖由 Brushless 於 2007-11-22 09:02 發表

                               
登錄/註冊後可看大圖

I have never used 松香膏.

just like chopsticks said, keep 你支野 surface clean, apply some 鍚 to both surfaces, then solder them together.

if 你支野 surface is dirty, the heat can't be conducted ...

唔該你先~but 我ga意思係d電線鬚同錫好難溶合..............

method not right?

原帖由 xrvct 於 2007-11-22 15:04 發表

                               
登錄/註冊後可看大圖

method not right?

買左松香羔~勁易焊~~~~~~