DX3R problem

Any DX3R owner here? i have a question about my DX3R!  I have set 4 "Model" in my DX3R, but everytime if i change to other model, i found that the receiver seems can't recognize my DX3R and i need to do binding everytime!! is that a problem or it is the characteristic of DX3R!!???  Or something wrong i have set ?

Thanks brother!

你唔可以就咁轉model,比如你同一部車有幾個setting
你每一個setting都要blind一次

應該係正常，係防止你誤用model 1既data 去玩 model 2既車。

ching我用dx3s都無呢個問題喎......就咁轉model就認到第二個接收.....唔係再bind

可能呢個就係DX3S 同 DX3R既分別

blind左一次就可以

原帖由 Tim718 於 2009-1-29 00:00 發表

                               
登錄/註冊後可看大圖

應該係正常，係防止你誤用model 1既data 去玩 model 2既車。

Then this is very trouble wor....

I use 3PKs before...it will also remember which receivered binded before in each model....

登錄/註冊後可看大圖

我明啦......樓主你係一個接收for 4個model memory.........咁ching 'tim718'就講得岩
我頭先誤會左係講緊4個接收.....................
我個dx3s未試過咁做.........聽日試下先

對於用開3pks 來講又真係幾麻煩下..  因為3pks有10個字改model名. 選錯model機會好小..

DX3S uses DSM which is old technology and it does not have ModelMatch. This is the reason why you can change the model on transmitter and don't need to bind them again.

DX3R uses DSM2 technology and it has ModelMatch and faster response time than DSM. Every time you change Model, you need to bind them again.

原帖由 powis 於 2009-1-28 23:04 發表

                               
登錄/註冊後可看大圖

Any DX3R owner here? i have a question about my DX3R!  I have set 4 "Model" in my DX3R, but everytime if i change to other model, i found that the receiver seems can't recognize my DX3R and i need to  ...

please take a look

http://www.spektrumrc.com/Articles/Article.aspx?ArticleID=1784

原帖由 BT 於 2009-1-29 13:17 發表

                               
登錄/註冊後可看大圖

please take a look

http://www.spektrumrc.com/Articles/Article.aspx?ArticleID=1784

Thanks brother, let me check it tonight!!