TEKIN RS PRO問題

我想問個HOTWIRE邊一項係教TURBO 同幾時著TURBO架?
試左好耐都試唔到 想請教下各位師兄
唔知會唔會有HOTWIRE詳解呢?

C HING想問下你...TEKIN RS PRO幾錢AR...???

我想問個HOTWIRE邊一項係教TURBO 同幾時著TURBO架?
試左好耐都試唔到 想請教下各位師兄
唔知會唔會有HOTW ...
tai1236 發表於 2010-7-28 08:56

                               
登錄/註冊後可看大圖

What version are you using?  V200, V203 or V208?

我都想知,我升級 Vegas 208 之後,在C1、C2都找不到怎樣調整個Turbo Delay

After you choose C1 or C2, you will also need to choose 'sensored mode' to set Boost, Turbo & Delay.

回復 5# hardmankam
收到,收工回家試試,唔該晒師兄

我都想知,我升級 Vegas 208 之後,在C1、C2都找不到怎樣調整個Turbo Delay
multiimage 發表於 2010-7-28 11:51

                               
登錄/註冊後可看大圖

Turbo is not pre-set in C1 or C2, both of them without any setting inside it. Therefore no matter you want tubro or not , You also need Hotwire to set Turbo or fine tune other setting in C1 or C2 first.
Beside of the above, to adjust tubro delay only in dashboard of Hotwire, the icon just located direct above tubro ramp if using V208

After you choose C1 or C2, you will also need to choose 'sensored mode' to set Boost, Turbo & Delay.
hardmankam 發表於 2010-7-28 12:42

                               
登錄/註冊後可看大圖

If it is V208, Boost is allowed to set in "Dual Mode" now as confirmed by Tekin.

出左V208 喇

整泥整去都好似冇咩料到 各位師兄不如post下自己d數據出泥呀 haha

回復 10# tai1236

what motor are you using?

LRP x12 果隻10.5T

其實 TURBO 著既時間 同力度 主要係調教邊個?

For 10.5R try:

FDR ~ 7.5 to 8.0
Sensored Mode
Boost = ~ 35
Turbo = ~ 10
Delay = ~ 0.4
Start RPM = 9xxx
End RPM = 22xxx
Ramp = 2

回復 14# hardmankam
delay 0.4咁耐??你玩條直路好長？
START RPM成萬轉？？

That is only a starting point (safe settings).  adjust based on your track and motor temperature.

我搵泥搵去都唔見有TURBO既字眼?

I will capture some screenshots for you later tonight.

Below are screenshots of v208 (or hotwire v5)
1) Pic1: Startup screen of 'Dual Mode'

登錄/註冊後可看大圖

thx 終於set到喇 唔該哂師兄