TA06 gear ratio

Dear all,

I upgraded to HW120A 2.1 for my TA06, using the original 68T/23T and the ratio should be around 6.42.
I am using a HW10.5T motor. The turbo setting is the recommended setting from HW manual. This setting is normal? Too agressive?

I have this question because the banana plug of the motor came off after 1-2 minutes run... not sure overheat or not.. (P.S. the motor is 2nd hand, not brand new)

Anyway, I reconnect all the wire again. See if any advise from all C-Hing here.

Thanks!

If the wire desolder itself it means the wire getting too hot becuase of the over current load. Try increasing the gear ratio say to around 7. And test from there. Cheers

照計唔會咁熔法,有冇check過motor temp. ?
我隻10.5都係用6.4,推盡turbo都冇事,照計應該冇問題

                               
登錄/註冊後可看大圖

Have a quick test at JV yesterday. After I re-wiring from esc to motor, still melted...
Fact:
Ratio should be 79/23 or 24. above 7
esc: HW 120A 2.1
motor HW 10.5T
open small turbo as suggested in the HW firmware spec.

Is that I shouldn't use the plug and should wire it directly from esc? Or I should get some better 錫?

Thanks all ~

師兄！英文我就唔識睇喇！
但見你張相條線好似上唔到錫(假銲)，試下甩左D腳直接銲線落摩打。
另外散熱扇掉返轉裝風向摩打吹，再唔夠散就係底兜开幾個窿等佢对流，咁散熱会快D
我係渣仔只識咁多希望幫到你。

you try claen motor.............

                               
登錄/註冊後可看大圖

ching     114T+28t SPEEDPASSION gt2.0+Dualsky z5 5.5t

你話banana plug, 即係蕉插喇....咁你換番哂 T 插或者Trax插喇. 蕉插頂唔倒大电流的, 会过熱, 会溶....