Thx for the video, now that I have seen it, I am sure they can add a part to it, this part should talk about how to make all those shock shafts guide though those shock guides smoothly.
The problem with this shock is , it is being made badly, if you notice when you are building the bottom part, after those high drag blue oring, you put the guide on, you can see it actually stick out, and when you screw the cap on , it will compress the o ring, and it will just grab on the shock shaft, the shaft cannot move freely. (similar at the top).
BTW, the piston , if you look closely, at where they drill the holes, the material has deformed, so that the piston is not round, and when it move though the shock body, it will also drag as well. |
收藏
勁正
嬲嬲
樓主
