yokom02漂移呔的問題

我今日買左02呔,裝左,岩岩試車,部車響我樓下果d花園地甩到好似氣x船咁,個地好似上次party個小型公園場咁嫁,有咩方法攪到佢冇咁甩,我用ta04(但到左停車場d地(光滑的)又好似冇咁甩~,點好

[ 本帖最後由 地獄羊咩仔 於 2006-2-8 21:57 編輯 ]

原帖由 地獄羊咩仔 於 2006-2-8 21:55 發表
我今日買左02呔,裝左,岩岩試車,部車響我樓下果d花園地甩到好似氣x船咁,個地好似上次party個小型公園場咁嫁,有咩方法攪到佢冇咁甩,我用ta04(但到左停車場d地(光滑的)又好似冇咁甩~,點好

用02 呔, camber 要較大. 後輪用 3 度會咬地D, 因為輪邊軟膠會有多D既接觸面.

咁頭呢

有無頭單..

有

i dont know how to set it too.....
i am using ta04
now my setting is
02 tire
soft damper oil(>50#)
soft front spring,medium rear spring
front and rear stablise bar
front toe in
front and rear positve(not sure,is that called positive) camber

My Toe:

  Front
[]===[]
  :     :
  :     :     <--- 由上面望落去
//===\\
   Rear



//===\\    <--- 由車尾水平望 (Camber = 3)

[ 本帖最後由 hkopium 於 2006-2-9 00:21 編輯 ]

原帖由 hkopium 於 2006-2-9 00:18 發表
Front
[]===[]
  :     :
  :     :
//===\\
   Rear

rear toe in?will it understeering ka???

原帖由 Jim 於 2006-2-9 00:21 發表


rear toe in?will it understeering ka???

尾 toe in 唔系幫助轉向咩.........

我想問點樣度Camber架.......

原帖由 D1仔 於 2006-2-10 17:06 發表
我想問點樣度Camber架.......

expensive solution - there has a deck with marks and use a special wheel to measure(very thin wheel).
(actually....i dunno how to use it...ask some pros...)
cheap solution - put your car on a flat and balance surface,then use a compass(圓規) ans ruler to measure

原帖由 Jim 於 2006-2-11 03:15 發表


expensive solution - there has a deck with marks and use a special wheel to measure(very thin wheel).
(actually....i dunno how to use it...ask some pros...)
cheap solution - put your car on a ...

Get a set of "set car tools"...  Topcad has a set of metal ones for 3xx - 4xx dollars.  I use Hudy plastic ones.....  but it really helps when it comes to setting up a car.........