ko既fet sevro~~~~~~~~~

我有個ko既fet sevro有fet線哥隻
係咪一定要有fet線既電變先玩到?????
咁我用mc800c用唔用到架??

有冇人可以答下我牙????
好重要架~如果唔係我就要用3003架喇~

You can connect the FET wire to receiver 5V wire together.  However, the servo speed will be slower.

U can direct connect to battery +

咪聽5#果個亂講,今晚我同你博

The FET wire in the KO servo is for connecting to 7.2V +. So, you should connect it to the + size of you battery (or the plug).  OR, If your receiver doesn't have BEC, you can connect the FET wire to the + of your reveiver.

If  your receiver have BEC and you connect it to the + of your receiver, +5V will be provied to the servo. It still works but the speed is low.

原帖由 101路霸 於 2007-9-16 22:17 發表

                               
登錄/註冊後可看大圖

如果你個電變唔支援或無fet線, 可以直接將servo條fet線加到電變接頭到接收機的正極(+)就可

但係會唔會慢左????我可唔可以直接焊落電變既正極到???

servo用6v電源要加電阻減壓！

佢個KO 有FET線 servo,係 行7.2V的.......可以直接到battery + or Reciver +

if 接到 有BEC 的reciver ..係 會行得慢D..的


P.S.  KO 好像好耐都冇出有FET線的servo 是嗎= =a?

原帖由 RGM-111 於 2007-9-17 02:23 AM 發表

                               
登錄/註冊後可看大圖

佢個KO 有FET線 servo,係 行7.2V的.......可以直接到battery + or Reciver +

if 接到 有BEC 的reciver ..係 會行得慢D..的


P.S.  KO 好像好耐都冇出有FET線的servo 是嗎= =a?

駛唔駛加inductor?

原帖由 kxxlka7 於 2007-9-17 02:16 發表

                               
登錄/註冊後可看大圖

servo用6v電源要加電阻減壓！

下????你冇野牙???
個servo最盡行8.4v喎~~~