ICE Charger and LiPo Battery

I'm going to change to Brushless system and buy Lipo battery.  I'm using ICE charger now, anything that I need to add so that I can charge Lipo battery or buy a new charger?

Thanks!

ICE 可差 4cell li-po 我都用o左差唔多成年lu

你由 #45 開始睇,  希望能幫助你      
http://bbs.rc-evo.com/viewthread ... ght=lipo&page=3

Thanks for your information.  May I know if I add balancer, which balancer will you recommend and how to connect?  Finally, how to set ICE to charge the battery!

Check Point Balancer, see this
http://bbs.rc-evo.com/viewthread ... ighlight=checkpoint

原帖由 explorer888 於 2008-3-27 23:48 發表

                               
登錄/註冊後可看大圖

Thanks for your information.  May I know if I add balancer, which balancer will you recommend and how to connect?  Finally, how to set ICE to charge the battery!

例如你差 2 cells 7.4v 4700mah
部幾個記憶咪 set :
1. Li-po
2. 4700mah  (Set o左之後差電最高A數為 4.7A)
3. 7.4V
4. 差電為4.7A
其餘果D我都係照 manuals set   
http://manuals.hobbico.com/dtx/dtxp4170-manual.pdf
5. Discharge Cutoff Voltage:
b. For Li-Ion/Li-Po batteries, the adjustable range is 2.5 - 3.7V per cell. A
setting of 2.8 - 3.0V is recommended. (我用2.9 不過好小用)
7. Cutoff Temperature:
The maximum temperature for Li-Ion/Li-Po batteries varies by cell
manufacturer, but as a general recommendation the maximum
temperature should not exceed 90-95°F (32-35°C). (我用 33 °C)
11. Maximum Charge Capacity:
For Li-Ion and Li-Po batteries, the adjustable range is 10-120%. It is
recommended not to allow these battery types to charge more than 105%
to 110% of their rated capacity. For safety precautions, it’s recommended to
keep this value close to 100%. (我用100%)

[ 本帖最後由 kwok7660 於 2008-3-28 11:48 編輯 ]

至於 BALANCER
我用 Hyperion LBA10A Net
可以 一次 BALANCE 6CELL (不過我都未BALANCE過 6 CELL咁多)  
http://aircraft-world.com/shopexd.asp?id=4913

[ 本帖最後由 kwok7660 於 2008-3-28 12:01 編輯 ]

Thanks a lot of the detail information, I will buy Lipo tonight!!!