DB01 rear universal dog bone problem

any brother have the experience on DB01 with the tamiya DB01 rear universal dog bone which feel the dog bone is little bit shorter than the origianl dog bone and very easy to "fly out" from the diff joint from the differential??

在油壓芯穿大約6-7mm介子就可解決問題

原帖由 powis 於 2008-3-29 04:53 發表

                               
登錄/註冊後可看大圖

any brother have the experience on DB01 with the tamiya DB01 rear universal dog bone which feel the dog bone is little bit shorter than the origianl dog bone and very easy to "fly out" from the diff j ...

Yes, I have the same feeling even my DB01 is still on building. (Not yet finish). So I have change it back to original dog bone la. 唉! waste money.

原帖由 ftbingobingo 於 2008-3-29 05:06 發表

                               
登錄/註冊後可看大圖

在油壓芯穿大約6-7mm介子就可解決問題

wow! need to add so thick 介子!
also need to add this in the front shock !!!?

原帖由 Patrick6 於 2008-3-29 08:39 發表

                               
登錄/註冊後可看大圖

Yes, I have the same feeling even my DB01 is still on building. (Not yet finish). So I have change it back to original dog bone la. 唉! waste money.

Oh...!
so that is design fault from Tamiya!!!???
well i also prefer change it back to original dong bone.

Tamiya give me back the money!

原帖由 powis 於 2008-3-29 13:33 發表

                               
登錄/註冊後可看大圖

Oh...!
so that is design fault from Tamiya!!!???
well i also prefer change it back to original dong bone.

Tamiya give me back the money!

算把啦, 就算用原裝狗骨, 後油壓過長的話chamber呔尺外面粒ball cup都會磨到後鈴內則, 加介子啦!! 前面a arm度有車架頂住, 可以唔攪