Hyperion Duo

Hi all! Yesterday I bought the Hyperion Duo charger from KWS, however I found out later the balancer adaptor that came with the charger will not fit my batt.. All my 2s batteries came with a 3pin balance port, but on the 606, it came with a 5 pin for 2S batt.. Is there any method to get around this? I knew Hyperion do make some adaptor for 3pin, did any zihing knew where I can buy this from KWS?
Also one more thing, when using balance charger, I do not need to connect the black and red charge cable, am I correct?
Thank you very much for all your help!

佢原裝果d插頭係唔合用的，要另外購買
义电 紅黑線及balance port 都要插。，如
果唔插怎算是平行义哩
都係唔明,就問反鋪頭老闆

今晚放相比你睇

Thank you! Can you please tell me where I can buy the correct adaptor? I will leave HK tomorrow so tonight is my only chance..
Thank you very much!

原帖由 joho 於 2008-9-7 17:10 發表

                               
登錄/註冊後可看大圖

Thank you! Can you please tell me where I can buy the correct adaptor? I will leave HK tomorrow so tonight is my only chance..
Thank you very much!

廣華街飛机鋪鼎豐模型，快去啦。
問老闆點用，

Thank you!

Thank you very much Mschumi! I have got everything I need from the shop you said, very good service too!

welcome