RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

標題: YR4 SP custom 2 speed [打印本頁]

作者: tiger1 時間: 2020-3-4 22:13
標題: YR4 SP custom 2 speed
YR4 好多人版本
我出 YR4 SP custom

作者: tiger1 時間: 2020-3-4 22:16
原裝尾 pulley can rub the motor mount, no good, slim down motor mount much better l. Also level out rear upper link. Original slanted, no good

作者: tiger1 時間: 2020-3-4 22:17
First on original. Last one photo faster steering.

作者: tiger1 時間: 2020-3-4 22:18
暫時放住 ONEWAY + slipper pulley

作者: sniper 時間: 2020-3-5 07:12
motor mount 自己開料??

作者: tiger1 時間: 2020-3-5 10:37

sniper 發表於 2020-3-5 07:12
motor mount 自己開料??

No la. Cut down original

作者: rexcheung 時間: 2020-3-5 17:35
Great machining on motor mount.

May I ask which chassis is your SP Custom? As 2~3 chassis photos posted on this thread. Thanks a lot.

作者: rexcheung 時間: 2020-3-5 17:38
One more question, is the belts length changed? Thanks again.

作者: tiger1 時間: 2020-3-5 21:48
Same belt. The car was a YR4 Sp= First generation YR4 with graphite chassis

作者: tiger1 時間: 2020-3-5 21:50

rexcheung 發表於 2020-3-5 17:35
Great machining on motor mount.

May I ask which chassis is your SP Custom? As 2~3 chassis photos p ...

This YR4 custom is using a self-designed chassis. The concept is to max out the mod in material & geometry base on what I think is the best. Ti screws too

作者: tiger1 時間: 2020-3-13 21:44
2 speed added 不過仲未得住

作者: tiger1 時間: 2020-3-13 21:55
YR4SP left
YR4m2 TypeJ Pro on right

作者: tiger1 時間: 2020-6-17 18:08
This 2 speed was designed with a ‘catcher’, on-off system, not smooth on shifting from 1 to 2 gear, chew up the spur gear 磨薑

作者: tiger1 時間: 2020-6-17 18:09
Machined it down, 改輕

作者: tiger1 時間: 2020-6-17 18:11
Done. Used OFNA 1/10 parts

作者: tiger1 時間: 2020-6-17 18:13
Part list from another bro on RCTECH

I did not make a new clutch bell, just trimmed down the Yokomo original clutch bell ;)

作者: tiger1 時間: 2020-8-14 21:25
又改多少少

歡迎光臨 RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區 (https://jk.rc-evo.com/xbbs/)