New gear on old stuff !

I use 好盈 4300kV to play my RC10T at TKO for almost a year. No problem.

If I remember correctly, the servo gear of (KO, Sanwa) are different from (Futaba, JR, MGTower )

My hobbywing 35A/9T system I doesn't have such kind of response. Don't know whehter it was due to the setting of ch2. You can try to
1. Switch ch2 from "normal" to "reverse" (or vice versa)
2. Swap the connections of any 2 out of 3 wires of the ESC/motor set

Hope it is of help

Ryan ching
1/. Ch2 normal + reverse means what ? The EX5UR is factory presetted REV.
2/. If swap any cable to BL motor, the run direction will be reverse.....it looks like cannot solve my problem... ...
gimsink 發表於 2009-8-30 23:19

                               
登錄/註冊後可看大圖

I mean you should switch the ch2 of your EX5UR from REV to NOR and then swap any 2 wires of the BL motor. As such, both "reverse" at transimitter and ESC would still let the car to go forward. I suspect the scenario you described was due to you used the "reverse" mode of your ESC as forward and hence the so call "no response" might be a protection. It is my guess only, don't know whether it is true.

wish you good luck

ha.... big pan la

gimsink hing,

I use HPI 4411 read tire, it is very good.

Ryan

I just know that some poor quality Hobbywing BL35A system will have such kind of response. i.e. when the throttle is bring pushed slightly, the motor will vibrate a lot and sound....clik...clik.... and then run very fast.