just make sure you take it all apart and check all parts.
When you put it back, do not forget to put a lot of black grease at the worm gears and threadlock all screws.
One very important must do is heat shrink tube at all CVD pins.
do not play it before you do all this, otherwise damage is surely show up shortly.
Thx so much for your advice. Are those Tamiya Grease good enough? Can you elaborate a bit on "how to heat sink tube at all CVD pin"?
I still have no time to put those electronics in yet
Thx so much for your advice. Are those Tamiya Grease good enough? Can you elaborate a bit on "how to heat sink tube at all CVD pin"?
I still have no time to put those electronic ...
fly175hk 發表於 2009-6-7 00:36
收藏
勁正
嬲嬲
樓主
