Modified Tamiya TA05MS & 416WE

Newly build Tamiya 416WE, The ESC has been put on battery side.
Any comment on electronic items layout?

Thanks All !!

put more weight to the front will make car more easy to drive

Yes, the ESC is Tekin R1 Pro.

why put the esc on rear right side ? for balancing ?

esc和鋰電都會發熱, 點解唔改receiver?

woooo...........水晶邊...........good !!............

ok wor, good try, how is the left right balance without adding weight?

So sorry, I don't have the equipment to check whether the left & right sides can be balanced. So I try to ask whether any brother has tried this idea before & got experience to share.

Thanks All !!

5# bravohk

Since the ESC is heavier than the Rx, so I tired this layout.

4# console001

Right, the idea is for balancing. However, the size & shape of ESC & battery should be considered.

Good idea!

8# yokomo


A cheap way is to use 2 screws to put on the button central holes of your chassis.

Do u know how much of the tool for checking balance from Hudy?
Thanks All !!

Atomic is around or below $100. hudy last time i saw it in "red star", if i remember correctly $100 each, so $200 total.

Very expensive for just a small piece of tool

So I will try yr method to use two pcs of screw 1st....

上個月在KWS 見到 HUDY chassis balancing tool, under $90~
用過覺得可當一個粗略估算,但應不算很精準, 因有時兩邊"差不多"時也可刻意令佢平衡地放係支釘上面...
所以後來又買左4個電子磅, 問題更大(但係該係好既方向), 因放磅個平面水唔水平,夠唔夠硬都好有影響, 如果係一般檯面, 只要隻手按下一邊檯面都會影響個讀數......用hudy的 set 車板又要先搞好個水平(仲未得閒搞)...
我都希望可以慢慢試下balance的東西, 因在hudy set車書中都冇詳細講呢樣野...

c hing有物新發現記得post出來交流下~

我打算下一步係架t3既底板度鑽多幾個孔, 試下度前後左右的balance...
或者更加理想整個行啤令的平台(有d似Tweak Station個概念...), 咁好似都唔錯...
又或者將4支balance釘裝在4個輪下度電子磅...
但也發現裝了避震是度唔到真實的weight balance, 唔知對不對~

Thanks again for yr suggestion & glad to exchange ideas of RC here.

actually, I want to try electronic balances method too. Please kindly advise what brand & capacity of electronic balances are being used.

This's so Good

有人一齊試呢樣野真係好玩呢!
我買左呢隻pocket scale, 特價中約$94一隻,(500g/0.1g increasing) :

登錄/註冊後可看大圖