Xcharger B6 how problem... and question

when i charge my lipo battery i only see the mah. that is charged at that time not the mah in the battery.
for example
i plug my battery and charger my battery is 4000mah
when i plug in the mah of charger start from 0 but there mah in the lipo already. how to see the left over mah.

one more question..
how to set the temperature safety on the charger. it doesn't come with the temperature sensor. i bought but but when i plug in i don't know if is plug correctly. and i don't know how to see the temperature.

please anyone help.

I want to know too, I have same charger

There are no way the charger know how much mah is left in your battery.  This is the reason why it only show the capacity being added to the battery.  For the temperature sensor.  When you are charging the battery.  Press left or right button (sorry I never use it so I can't really remember which way...), but anyway keep pressing and you should be able to find one page displaying the temperature.  So you can see if the sensor is working properly.  

回復 3# jf813


    can you tell me hot to set the safety option. on the B6 i scared of LIPO.
like the temperture, time , and charge rate.

for example if i have 4000 mah 15c both 7.4v
                                 3000 mah 30c

If you use 1c to charge the battery usually it will take around 1 hour if you use balance mode.  So set the timer to 75min should be very save.  and set the capacity limit to 4000 for 4000 battery or 3000 to 3000 battery. As usually there should be a little power left for lipo.  

回復 5# jf813


    just one question for the same battery. if i set to 4000mah. because when i charger there maybe over 30% of battery mah left . that still safe?
like my battery 4000 mah i only used about 2000-3000mah.. because lipo cannot used all cause it will get FAT. right so when i charge still set to 4000mah? like 4000mah i used 2500 mah.. then 1500mah left and i charge 4000 in ?
  so when will the charger stop.. when the voltage reach 8.4?