有關電車差速

回復 18# GigaRacer [/隊


no problem~過1,2天我會放上來的~架車係車埸

C hing, got the picture yet?  

NT1 front gear diff + pully.  Bearing will fit, right?  How about dog bones?  

For T2/T3.  thanks!

回復 22# GigaRacer
有相喇!!!!等好耐...唔好意思!!

C hing, thank you so much!

Looks like it's the rear NT1 diff.

回復 24# GigaRacer

係..無錯...呢隻係尾牙差

I compared T2008 and NT1 manual.  Bearing size has no problem.  But I still think NT1 front diff maybe easier to make, at least no cutting on the diff.

回復 26# GigaRacer

Thank you C hing.  

From the first picture: NT1 front diff, NT1 rear diff, and Spec R diff, correct?

So, should use NT1 rear diff, right?  Any change for the dog bones?  Thanks!

回復 28# GigaRacer


但我見有人用NT1前差速呀, 你可去紅X攞老闆架車睇下, 佢用前差速嘅, 我T3就要用50mm狗骨

my problem is..... i am not in HK.

回復 30# GigaRacer


你在...................加州

Yes....

Here is the NT1 rear diff.  How do I cut it?

here is the front NT1 diff.  Do the holes match with the 38T pully?  I know I need to cut the center part of the pully.  Thanks!

對不起!我全是買二手回來的, 幫不了你答這問題, 要請其他ching幫手解答

對不起!我全是買二手回來的, 幫不了你答這問題, 要請其他ching幫手解答
raman9551 發表於 2010-8-3 14:48

                               
登錄/註冊後可看大圖

咁你2手反黎幾錢?

回復 35# mike20192


$3xx

回復 36# raman9551

如果你隻牙差係ANDY度買,那應該是TRC的其中一位C兄做的~

must use rear diff nt1, use 磨機 , 磨去pulley90%餘下約2MM邊(等於T3 diff pulley內徑)
磨去t3 diff pulley內多餘的物料(可以塞入rear diff nt1)但要留4個孔上鏍絲
注意T3pulley其實騎住nt1 diff 邊0.5MM, 所以要加AA膠, 最後將T3 PULLEY膠圈吸回去,
,牙差杯磨闊D, OK晒!

gtimax c hing, thanks for the great info.

有唔明再問啦!