nice car! mine's only put the TRF damper and front alum. drive cup, and i found many option/set up parts on your car which is very nice, did you change the axle shaft and drive cup from plastic to alum.? what brand is it? and what about the steering hubs, are they from HPI or Jet racing?
Well, after a few crashes....... had to replace it with stronger parts. The drive cup is GPM's, and the steering hub is HPI's! Anyway, I've tested the car again today (no crashes today lucky), the stand up shocker set up seems to be better. May be I have used a hard anti-roll bay, the car became too stiff and spin out all the time. I'll change it with a soft one and see how it goes!!
i couldn't found on their website they carry the drive cup (center shaft drive cup) or Axle shaft (the universal shaft) anyway, i may order some option parts from HR.
The hard spring and hard anti roll bar should not make the car spin as i know a little knowledge on setting, did you check the front and rear suspension parts and damper can move up and down smoothly? make sure 4 wheels is on the road when you apply the corner and turning, what tire are you using now?
i still searching any shell can fit on the cup racer, the Tamiya mini cooper is too short in the front, not fit.
Any cup racer player can tell me what type of body you are using now?
樓主: gavl
[複製鏈接]
樓主
回復 
