Tpm electronic speed controller

Is the Esc still available in the market?

好似仲有TPM8,有錯請指正

I think there is

Thank you Ching. Where can i buy tpm8?

德寶都有出無刷電変嫁

你去（至落）睇睇

又或者直接去深水埗縂壇搵

anything good about TPM esc ......apart from 支持本地製造 ??......

回復 minimini 的帖子

because I used Tpm2 since 20 years ago, then I used tpm3, and 5. Other than tpm2, they are not damaged easily: I used trinity 52000 rpm motor. I support this hk products just because it is not bad. Why we have to buy substantially more expensive but slightly (maybe) better foreign products?

that's why I said "other tan tpm2". 52000rpm trinity motors are the pink ones bought from ct hobbiy

回復 BUNNYYUEN 的帖子

Thank you

support hk products

the rpm quoted by Trinity was a bit tricky.....they actually using 12V to get the data......while all other brands were using 7.2V .......

回復 minimini 的帖子

really? But it made my lazer very fast.

bear_cat_x 發表於 2012-6-17 07:33

                               
登錄/註冊後可看大圖

回復 minimini 的帖子

really? But it made my lazer very fast.

sure.....

during that era........Reedy modified (hand-winded 14T) usually had ~ 28000 to 32000rpm at 7.2V (as quoted by the factory).......

while Trinity started to release some sort of hand-winded 11T, 12T motors...... plus 12V as the testing voltage.....which pushed them up to 52000rpm.......of course if they were all using 7.2V...... 12T Trinity should still be faster than 14T Reedy.......

TP quality is actually not bad but QC sometime is a problem. Good that you can get them fixed in HK easily. Cheap too

絕對支持香港產品，大家記吾記得大約10几年前有架1：10叫seven 都系香港人設計，另外以前在灣仔橋底場附近有間叫星星模型有個車仔設計賣咗比日本仔之后就發咗吾使點做，而得寶的售后服務亦相當滿意，就算你個電變BBQ都好，頂多味收你一舊，仲要你飲個茶轉頭攞，ok嫁

回復 BUNNYYUEN 的帖子

Where is tak po now?

系深水埗高登商場對面好似系福仁商場一樓

回復 BUNNYYUEN 的帖子

Thank you Ching. It seems that tak po is still at the same location as 20 years ago.