Team Powers 電子變速器玩家專區：

我想問隻 Radon Sport 95A 幾時出呀？部頭驅等緊佢

brianych 發表於 2014-5-19 20:03
我想問隻 Radon Sport 95A 幾時出呀？部頭驅等緊佢

6月初將會有

rc.explorer 發表於 2014-5-20 10:39
6月初將會有

Good News. Thanks

顶顶顶

不開增壓，怎樣才能有它本來70a8.5T的速度？？因為本人放在dt03不想要增壓，但是不知道為何比我本身用開的3600Kv無感還慢還差……？？

想請問radon 140a pro, jv setting

10.5t

echok700i 發表於 2014-5-24 21:18
10.5t

Radon program ver: V1.4(test program)+ Plutonium V2 10.5T
TH1: Punch Rate A: 15
TH2: Punch Rate B: 20
TH3: TH SW Poiint: 50%
TH4: Slope: Linear
T1: Timing Boost: 40
T2: BT Start RPM: 8000
T3: BT End RPM: 16000
T4: Boost Slope: Linear
T5: Power Saving Mode: No
T6: Turbo Boost: 20
T7: TB Activation: TH
T8: Turbo Delay: 0.1s
T9: TB Start RPM: ---
T10: TB on slope: 21deg/0.1s
T11: TB off slope: 12deg/0.1s
T12: Turbo K LVL: 10
T13: Turbo T LVL: 0

Plutonium V2 10.5T Motor  timing at -2 position, 12.5mm roar rotor, FDR = start from 7.8

rc.explorer 發表於 2014-5-24 21:41
Radon program ver: V1.4(test program)+ Plutonium V2 10.5T
TH1: Punch Rate A: 15
TH2: Punch Rate  ...

謝謝解答，售後服務好好，還會繼續支持。還有我齒比是6.4是否用你建議的setting。

echok700i 發表於 2014-5-24 23:05
謝謝解答，售後服務好好，還會繼續支持。還有我齒比是6.4是否用你建議的setting。
...

你下載新的v1.4程式後先按設定用FDR為7.5試幾個圈, 如不多快, 再把FDR慢慢調下去.

Please Chings
I am using a combo set of XPS Sport 70A v2 with 13.5T cup racer motor.
However, it only response to forward but no reverse.
Had been try to set 中位. but there are still no reversing!
PS: i use a Futaba 3PL transmitter and receiver.

I am using sport 95a with 13.5t motor. However, the car only move forward, but it can not go backwards? tks ching.

willislaw 發表於 2014-7-2 20:46
Please Chings
I am using a combo set of XPS Sport 70A v2 with 13.5T cup racer motor.
However, it onl ...

In program card "Running mode" items, you can set it to Fwd/Rev, then the esc will perform the reverse function.

dream86 發表於 2014-7-3 00:23
I am using sport 95a with 13.5t motor. However, the car only move forward, but it can not go backwar ...

In program card "Running mode" items, you can set it to Fwd/Rev, then the esc will perform the reverse function

Thx rc.explorer
Do we have to set 中位 again, after the program card setting?

willislaw 發表於 2014-7-3 20:55
Thx rc.explorer
Do we have to set 中位 again, after the program card setting?

better you set the neutral point after you set it to fwd/reverse.

Tks rc.explorer

請問(XPS Pro 140A)、 (XPS Sport 70A) 是否都必須要用個別指定的設定咭？
單用現有的設定咭已可設定turbo 功能嗎？是否要另外經電腦下載程式才有turbo 功能呢？
勞煩幫忙。

烈火2010 發表於 2014-12-8 21:17
請問(XPS Pro 140A)、 (XPS Sport 70A) 是否都必須要用個別指定的設定咭？
單用現有的設定咭已可設定turbo ...

XPS Pro 140A 要用這一款 program card。

烈火2010 發表於 2014-12-8 21:17
請問(XPS Pro 140A)、 (XPS Sport 70A) 是否都必須要用個別指定的設定咭？
單用現有的設定咭已可設定turbo ...

Radon 系列兩款應共用，之前的 XSP PRO/SPORT 1.0、1.1 等各要用回自己系列及不能用電腦調整。