分享 XV-01 自制底板過程（用左底板嘅師兄請留意55樓）

yin@hk 發表於 2013-6-8 09:50

                               
登錄/註冊後可看大圖

洗唔洗cut膠件先裝到架?thx

要cut兩刀，或者你唔cut都ok, 但無咁好睇囉

c兄底板？$Thank!!

利害, 利害

Good!  How much per set?

ching,有興趣，請pm,thx

Ching, I also interest, how much ar?

師兄幾$?

I am interested too...

Ching, I also interest, how much? Please PM.

Can this one become FF XV. Front wheel only?

SamsonSung 發表於 2013-6-11 12:19
Can this one become FF XV. Front wheel only?

四驅，FF，FR 都可以。基本上touring同drift都玩哂

updated !! 第一批到左貨 !!

ching,有興趣，請pm,thx

第一二批貨都已經派哂比師兄，黎緊會係第三輪，如無意外會o係weekend有貨。之前收到貨嘅師兄，如果有件炒左，或者有問題，可以搵返我，我有做多到spare件的

最後要提一提，轉向部份砌法同正常說明書砌法有出入，應該參考V1嘅砌法，同時轉向L臂亦要升高波頭（橙圈內波頭要升高，可以用二樓板支撐柱之類），先可以用推捍連到servo saver

                               
登錄/註冊後可看大圖

題外話，無意中想到可以用浮式servo座做到橫servo擺法，但要落手去DIY，之後有時間會貼相出黎

I'm using my TC Pro for your chassis. However, the tie rods connecting the steering bridge would hit the two suspension separation mounts unless I raise the entire steering mechanism by like 10mm. Any suggestion as to how this can be resolved?
Thanks David.

edison0918 發表於 2013-8-1 13:40
I'm using my TC Pro for your chassis. However, the tie rods connecting the steering bridge would hit ...

無錯，如果唔升高的話係會揰到，升高2mm即可。向當初講漏左嘅各位師兄講句唔好意思

Great design and contribution.  Can you PM me the price? Many thx.

師兄幾$?