岩岩差到舊電...

原帖由 bkingsanc 於 2007-1-11 00:12 發表


咁我成排電比佢，佢check唔check到邊粒死嫁?

我見 3 餅 GP 4300 死
其中 2 餅的死電是白一點的
另一餅起粉

應該用肉眼都分到
不過 o的人用錶一度就知了

電池溫度不應高過42度C

我都好灰咁樣燒左舊電~
聽日就拎舊電出去睇下有無得整~
再用埋之前玩槍舊9.6v 2400電改埋7.2v
因為星期五晚有party
anyway 唔該晒各位解答

其實我個差機差夠就識停嫁啦~
不過見夠電唔熱諗住谷一谷佢
點知谷爆左

原帖由 bkingsanc 於 2007-1-11 00:32 發表
其實我個差機差夠就識停嫁啦~
不過見夠電唔熱諗住谷一谷佢
點知谷爆左

should be measured on temperature rise (< 20C), not absolute temp.

哈哈, 我頭先諗住加返粒新電落排橫電度(因為有粒死左要replace), 已經焊得好好, 焊完粒電都只係暖暖地, 點知一去差電, @#*佢丫, 好似水滾噤聲重要嘔埋水

need to make each cell to have same amount of 電 left. If the new cell is near fully charged and the other five is empty you will get 水滾

You are right, 死電是好灰.....  I have a dead Epic 3800 stick pack.  I had to unwrap it, and make it a side by side, and put it on a Trinity DPD to identify which one dead.  I thought it's recovered because I can charge it to 4200 after the re-conditioning.  But the dead cell still not holding charge.  

that's why I want to go for Lipo

原帖由 GigaRacer 於 2007-1-11 01:42 發表
You are right, 死電是好灰.....  I have a dead Epic 3800 stick pack.  I had to unwrap it, and make it a side by side, and put it on a Trinity DPD to identify which one dead.  I thought it's recovere ...

LIPO 唔係仲易死咩?

Really?  At least no need to discharge.  Orion already has low cut-off in the battery.  Longer run time, good power.  Can't think of any bad thing about it except the price

原帖由 Rcrounder 於 2007-1-11 01:24 發表
need to make each cell to have same amount of 電 left. If the new cell is near fully charged and the other five is empty you will get 水滾

原帖由 GigaRacer 於 2007-1-11 01:42 發表
You are right, 死電是好灰.....  I have a dead Epic 3800 stick pack.  I had to unwrap it, and make it a side by side, and put it on a Trinity DPD to identify which one dead.  I thought it's recovere ...

我已經先將排電放落部 MUCH MORE放電機度放電先(CTX-D), 但係顯示粒電無電壓(0.00V), 噤我咪諗住差佢睇會吾會係粒新電電壓太低所以無顯示囉, 點知差左幾分鐘就出事啦 , 粒電正極果邊出晒水呀 , 就噤樣粒新電就死左啦

原帖由 bkingsanc 於 2007-1-11 00:03 發表


咁即係會燒電變?
重有如果咁情況係會燒晒6粒電定係其中一兩粒?
如果係其中一兩粒，我又可唔可以落廣華街買返兩粒再叫人焊返落去呢?
thank you

唔會燒電變架 又唔會燒晒6粒電同其中一兩粒

除非你差死佢

原帖由 卡洛斯．馬 於 2007-1-11 00:03 發表

2年前試過燒.....但係未確定到係唔係關舊電事......

2年後都繼續燒其它野.....但係未確定到係唔係關舊電事

直路你都未識行啦....ma生.....

原帖由 AlexFiona 於 2007-1-11 01:54 發表




我已經先將排電放落部 MUCH MORE放電機度放電先(CTX-D), 但係顯示粒電無電壓(0.00V), 噤我咪諗住差佢睇會吾會係粒新電電壓太低所以無顯示囉, 點知差左幾分鐘就出事啦 , 粒電正極果邊出晒水呀: ...

用幾多A差?

原帖由 ck 於 2007-1-11 12:07 發表


唔會燒電變架 又唔會燒晒6粒電同其中一兩粒

除非你差死佢

岩岩拎左落廣華街搵電王整，佢都話未必有事，叫我放心用

原帖由 bkingsanc 於 2007-1-11 14:49 發表


岩岩拎左落廣華街搵電王整，佢都話未必有事，叫我放心用

who is 電王?

原帖由 馮馮ymc 於 2007-1-11 00:10 發表

你條死仔

http://bbs.rc-evo.com/viewthread ... page%3D1&page=4

睇返卡洛斯O架車......幾個問題.

1.SERVO SAVER安裝錯誤,冇裝最後蓋片就上螺絲,成個SERVO SAVER根本就 ...

咁似我ga?

原帖由 ck 於 2007-1-11 22:12 發表


who is 電王?

我d朋友係咁叫嫁，係巷仔入去右手邊第2間！

原帖由 bkingsanc 於 2007-1-12 12:55 發表


我d朋友係咁叫嫁，係巷仔入去右手邊第2間！

有兩條巷